Examples of 'hand-tighten' in a sentence
Meaning of "hand-tighten"
To hand-tighten means to screw or fasten something using one's hands or manual force, without the use of tools or devices
How to use "hand-tighten" in a sentence
Basic
Advanced
hand-tighten
Hand-tighten the impeller until it is secure.
Reconnect and hand-tighten the hose fitting.
Hand-tighten only using an appropriate screwdriver.
Connect regulator valve and hand-tighten firmly.
Hand-tighten screws do not use electric driver.
Connect regulator valve and hand-tighten fi rmly.
Hand-tighten the connectors to avoid damaging them.
Screw housing into filter head and hand-tighten.
Hand-tighten the hardware for further adjustment.
Replace the fuel cap and securely hand-tighten.
Hand-tighten drinking lid onto travel jar.
Screw a nut onto the bolt and hand-tighten.
Firmly hand-tighten the handle adjustment knobs.
Screw bottom of housing onto the cap and hand-tighten.
Hand-tighten the rod for further adjustment.
See also
Replace the battery compartment cover and hand-tighten it with the coin.
Hand-tighten the lid to make an air tight seal.
Thread the contact tip into the end of the gun and hand-tighten securely.
Hand-tighten the union nut to the pipe joint.
Check the coaxial cable at the rear panel and outlet and hand-tighten if necessary.
Hand-tighten the attachment knob to secure the attachment.
When the specimen is secured, hand-tighten the final two contacts screws in the middle ring.
Hand-tighten the nuts to allow a bit of play during assembly.
Thread the decorative flange clockwise into the orifice and hand-tighten until secure against the wall.
Again only hand-tighten these screws at this stage.
Screw bottom of housing onto caps WITHOUT inserting prefilters and hand-tighten.
Hand-tighten the compression nut onto the cord holder.
Thread each antenna on to an antenna connector on the Access Point and hand-tighten them.
Hand-tighten the screw connections using the appropriate tool.
Thread each antenna onto an antenna connector on the Access Point and hand-tighten them.
Hand-tighten the garden hose fitting onto the garden hose.
Place the Record on the platter and hand-tighten the record clamp onto the spindle.
Hand-tighten the coupling nut clockwise until it comes to a full stop.
Close the cover and hand-tighten the thumbscrew J.
Hand-tighten the shield cup until it is seated on the torch head.
You only need to hand-tighten the filter.
Hand-tighten the first locking collar securely onto the handle.
Replace oil fill cap and hand-tighten.
Hand-tighten the clamp around the tubing to secure the humidifier drain.
Install oil fill cap / dipstick and hand-tighten.
Hand-tighten the water supply fitting onto the cold water faucet.
Tighten the fitting onto the inlet valve - hand-tighten only.
Screw in and hand-tighten the new adapter as tight as possible no tool is needed.
Align the underwater camera to the light 's mounting screw and hand-tighten.
Hand-tighten the locking collar of the spray tube securely onto the adapter.
For a plastic fi tting, hand-tighten the nut and do not over tighten.
Hand-tighten each screw onto the puck until the puck stops turning.
From the bottom of the backrest, install and hand-tighten the two screw knobs.
Hand-tighten the stand mounting hardware until you attach the machine to the stand.
Connect screw on the 1 lb LP tank and hand-tighten firmly.
