Examples of 'head bolts' in a sentence
Meaning of "head bolts"
head bolts - Refers to the bolts used to secure the cylinder head to the engine block in a mechanical assembly
Show more definitions
- plural of head bolt
How to use "head bolts" in a sentence
Basic
Advanced
head bolts
Hammer head bolts with spring ball.
Replace and tighten hex head bolts.
Tools for pent head bolts are commonly available.
Loosen the two socket head bolts.
Hexagon head bolts with entire length thread.
Be sure of proper torque on head bolts.
Longer head bolts needed because of the change.
Tighten the socket head bolts.
The compressor head bolts should be kept properly torqued.
Place a flat washer on each of the hexagonal head bolts.
For the head bolts.
What happened was they got some new head bolts.
Hex washer head bolts for attaching canopy to chimney support.
Then secure the hex socket head bolts very carefully.
Head bolts do not pull on the cylinder wall causing distortion.
See also
The tightening of cylinder head bolts should be carried out by a specialist.
Secure burners to back of firebox with Phillips head bolts.
They are also known as mushroom head bolts or dome head bolts.
Insert hex head bolts with flat washers through the saw base and.
Check the three hex flange head bolts for final tightness.
Air leaks between Be sure of proper torque on head bolts.
The required hexagon head bolts are included in the delivery scope of the loudspeaker.
Air leaks between head and Be sure of proper torque on head bolts.
Check the torques of the head bolts after the first five hours of operation.
I wish I would have been a little more patient and waited to loosen up the head bolts.
Use the four short hex head bolts and four hex nuts to secure.
Head bolts are screwed into the threaded holes, respectively.
Then secure carefully the hex socket head bolts on either side of the base.
Open the two hex head bolts using a suitable socket spanner and remove the stone holder.
Item Custom CNC milling stainless steel Ball head bolts and fastener Ball head bolt.
Hammer head bolts with EPDM insert.
To fasten correctly, always replace the cylinder head bolts.
Remove the six hex socket head bolts using a hex wrench and remove the rear cover.
Remove the left rear wall by opening the 3 top hex head bolts.
Come complete with stainless Allen head bolts to hold the upper to the lower clamp.
After two weeks, tighten all nuts and bolts including head bolts.
Loose cylinder head bolts Tighten properly.
Preferably, the cross fins are located in part between these two head bolts.
Re-torque head bolts only after pump has cooled.
Tighten the 2 previously loosened Phillips Head bolts.
Double hexagon head bolts may not be oiled or greased!
Using a 4mm hex key, remove and retain the hex socket head bolts in the.
Mushroom head bolts with large head, double slot.
I can't find where the head bolts were changed.
The head bolts must be re-torqued ( retightening process ) regularly.
Using the supplied wrench, remove hex head bolts securing the vise to the cut-off saw.
Secure steering arm to gearbox with spacers ( B ) and hex head bolts A.
Open the 4 hex head bolts and remove the two stone holders.
Secure the motor to the motor adapter with the ( 4 ) hex head bolts supplied with pump.
Tighten the two hex head bolts that were loosened in STEP 3.
