Examples of 'hole locations' in a sentence
Meaning of "hole locations"
hole locations: This phrase is often used in the context of golf to refer to the positions on a golf course where the holes are located, each with its own unique challenges and characteristics
How to use "hole locations" in a sentence
Basic
Advanced
hole locations
The mounting hole locations are not correct.
Please refer to the diagram for hole locations.
Mark the bracket hole locations with a pencil.
Ensure that no studs are behind the hole locations.
These hole locations are a recommendation only.
We started by marking the hole locations.
Mounting hole locations viewed from front of heater.
Topsoil was encountered at ground surface at all test hole locations.
Mark the hole locations on the backside of the auxiliary fence board.
Level wall plate and mark the hole locations.
Mark the hole locations on the workpiece and center punch at these locations.
Clamp panel in position and mark pilot hole locations.
Mark the hole locations from the backside of the miter saw fence.
Locate the amplifi er and mark the mounting hole locations.
Drill the marked hole locations all the way through the auxiliary fence.
See also
The blackened holes in the shaded areas are ideal hole locations.
Mark with a pencil the hole locations for screws and duct in the ceiling.
This figure depicts tap hole and screw hole locations only.
Mark on wall the pilot hole locations through the template and remove template.
Level the wall plate template and mark the hole locations.
Mark pilot hole locations on the surface on which you will be mounting the cradle.
Tip range onto its back to expose foot cover mounting hole locations.
Mark hole locations for filter head and bracket in a spot that allows for filter replacement.
Use the included mounting template to help mark the mounting hole locations.
Lay out the hole locations on the workpiece and CENTER PUNCH at these locations.
Carefully level the unit using shims as required at all mounting hole locations.
Mark the hole locations with a pencil, nail or awl.
Other cutting heights can be obtained by positioning the bolts through other hole locations.
If drywall is present, mark the screw hole locations for the top mounting brackets.
Place the charger against the wall and mark the two hole locations.
Maps showing hole locations and the geophysical interpretation are available at www . osiskomining . com.
Place the sunshield over that hole and mark the mounting hole locations.
Add to that, the hole locations for round 4 were once again expected to provide a challenge.
Drill pilot holes in the chimney support mounting hole locations for your attachment method.
Drill hole locations are shown on Figure 2.
Using the swivel base as a template, mark the pilot hole locations.
Attach mounting brackets at hole locations ( A ) in the burner box bottom with mounting screws.
Using the base as a template, mark the screw hole locations on the wall.
NOTE, Mounting hole locations should be into the ceiling support structure.
Use a level to square the wall bracket and mark the remaining pilot hole locations fig 2b.
NOTE, The mounting hole locations must span the studs.
Install framing for hood support If drywall is present, mark the screw hole locations.
Mark 2 screw hole locations in the wall.
Use the Wall Plate ( c ) as a template to mark the two hole locations on the wall.
Mark 2 hole locations in each anti-tip bracket.
Mark 2 lower mounting hole locations.
The screw hole locations are aligned with the slots 2 and 3 in the stem 7.
Choice of 2 mounting hole locations.
Drill hole locations are shown on Figures 2 and 3.
Level the wall plate 14 and mark three hole locations.
You'll also be interested in:
Examples of using Locations
Show more
Those locations are shown with hatch lines
Prepare holes at fastener locations as identified below
Storage locations across thousands of different sites
Examples of using Hole
Show more
So does that giant hole in the wall there
The hole of the steam spout is clogged
Cut the piping hole sloped slightly
