Examples of 'hole size' in a sentence
Meaning of "hole size"
Hole size refers to the diameter or dimensions of a hole or opening in an object. It is usually measured for the purpose of determining the appropriate size of a plug, screw, or any other object that needs to fit into or cover the hole
How to use "hole size" in a sentence
Basic
Advanced
hole size
Hole size can be design as your requirement.
Carefully control the molten hole size.
The black hole size is much smaller.
Product alloy thickness width hole size.
Central hole size of blank holding slide.
The same applies for the hole size.
Color hole size mix ratio flow rate.
This term removes the effect of the hole size.
The hole size dictates the strand size.
Also we attached our available mold of hole size as follows.
The hole size and diameter can be modified.
Lower hole size.
Another feature useful in defining these preferred foams is hole size.
The hole size is large.
Drill and tap the correct hole size for fastener.
See also
The hole size will vary depending on the particular procedure being performed.
To go sure please measure the hole size of your rim before ordering.
But is advantageous for them to have the same mesh or hole size.
Another method is to provide a distribution of hole size relative to the distribution of resistance.
Use only the recommended diamond wheel with the correct hole size.
Please note the hole size on the wall bracket when choosing hardware.
It assists you in cutting the appropriate hole size in the bulkhead wall.
The shape and hole size can be produced according to the specifications of user needs.
Back pressure in an extruder is typically increased when die hole size is decreased.
The hole size of the mesh can be customized apart from standard configuration as optional.
The laser power and beam diameter is adjusted to achieve desired hole size.
In general the optimum hole size will be determined by specific study and verified empirically.
It has been found that the total power increases essentially linearly with hole size.
The die exit hole size also determines the amount of thermoplastic that surrounds the roving.
The guide wire is then over drilled with a cannulated drill to increase the hole size.
Drilling Calibration process for multiple hole size on the same work piece.
Natural rubber is softer than EPDM rubber for a given thickness and hole size.
Wire Diameter and Hole size can change.
If the hole size is larger than recommended i . e.
Plating Min hole size.
The hole size must be in accordance with the duct manufacturer 's instructions.
Alternatively, the hole size may be variable.
Approximate number of holes, and smallest hole size.
Material thickness format hole size pitch passage weight per m ² article no.
In principle, there is not much limit to black hole size.
As drilling progresses to greater depths, the hole size is normally reduced at intervals.
Minimum hole size if drain hose and inlet hose are through same hole is 2.
Try to force mounting, alter or enlarge the arbor hole size of wheels.
The hole size of the mesh can be customized apart from standard configuration ;.
When a low water content composition is used, the vent hole size is less important.
Obviously, selected hole size and degree of perforation contribute to the flow situation.
They can survive a five-story fall, swim for six hours crawl though a hole size of a quarter.
No-one had expected that black hole size and galaxy size could possibly be related.
Figure 4 illustrates the correlation between Padres Number, weight loss and hole size.
When larger hole size spinnerets are used, the extruded fibers may be collected onto a tray.
You'll also be interested in:
Examples of using Size
Show more
Change duct size gradually to minimize turbulence
I do not want a comedian knowing my dress size
Size expressed as minimum and maximum weight
Examples of using Hole
Show more
So does that giant hole in the wall there
The hole of the steam spout is clogged
Cut the piping hole sloped slightly
