Examples of 'holes must' in a sentence
Meaning of "holes must"
holes must: This phrase suggests that there is a requirement for holes to exist or be created in a certain context. It could be used in various situations, such as construction, crafting, or design, to emphasize the necessity of having holes
How to use "holes must" in a sentence
Basic
Advanced
holes must
Four holes must be used for mounting.
The distances between the holes must be equal.
Black holes must give off radiation.
For a higher rate of advance the holes must be lengthened.
Drainage holes must be in center of grower.
This method presents the notable drawback that additional holes must be machined.
Holes must be completely sealed off with masonry.
Ventilation holes must be kept clear.
Holes must be drilled in order to secure the saw to the tool mount.
The axis of the holes must be parallel to the ground.
Holes must be made on the panel according the specific dimensions of your handle.
The water outlet holes must be kept perfectly clean.
Holes must never be drilled in the motor housing e.g. for attachment of nameplates.
The depth of the bore holes must be the same length.
Vent holes must not become blocked or covered.
See also
The bracket fitted in the corner drill holes must always be flush to the wall.
The holes must not be covered.
Exterior Construction Areas All open excavations and pier holes must be guarded or protected.
Pier holes must be guarded or protected.
Accordingly, the radiation holes must be formed small.
The holes must go all the way through.
Accordingly, the ventilation holes must be formed small.
The holes must be closed through a transparent sealant.
In practice this means that holes must not be in the preparation área.
The holes must be filled before we demand further funds.
The end with the two treaded holes must point at the rear of the machine.
The holes must be the same size as the dowels.
When fitting kitchen fronts, holes must be drilled in drawer fronts.
The holes must be towards the front of the gas grill.
Beyond which black holes must form at their center?
The holes must be drilled centrally relative to the marked points.
In the same way, the diameter of the holes must be proportionate.
Surface with holes must be at bracket end of shelf.
In order to flow the oil in an enclosed space, the holes must be sealed.
Most black holes must spin at least a little bit.
For this recirculating installation, the vent holes must be positioned at the top.
Any drainage holes must be closed off during the test.
If the sleeve is damaged during installation, the holes must be sealed water-tight.
Any drain holes must be closed off during the test.
After the casing is cast, the mounting holes must be mechanically worked in.
All open holes must be constantly supervised by persons at the hole.
If the site is on an incline, planting holes must be terraced into the hillside.
The holes must then be made before the heat treatment.
The dimensions for distances, openings and drill holes must be precisely adhered to!
The release holes must then be filled to close the cavity.
As a result, they concluded that the black holes must be spinning extremely rapidly.
Deck bolt holes must be drilled parallel and square to mounting faces.
As to current status, they claim that black holes must be able to leak information.
These holes must be facing down towards the grease trough to be effective.
When an alignment die is used, alignment holes must be added to each green-sheet layer.
