Examples of 'holes should' in a sentence
Meaning of "holes should"
holes should - This phrase seems incomplete or out of context and does not have a clear meaning in English
How to use "holes should" in a sentence
Basic
Advanced
holes should
The ventilation holes should not be covered.
The holes should be as deep as the wall is going to be high.
The lower set of mounting holes should be used.
The holes should match on both pieces.
Each of the four mounting holes should be bolted.
The holes should be round and not.
Dirt entrapped in corners and holes should be removed.
These holes should go all the way through.
The distances between the holes should be equal.
These holes should be directly below the electrical boxes.
Loose shingles should be repaired and holes should be patched.
These holes should be as small as you can make them.
Stumps were to be grubbed out and any holes should be filled in.
Holes should be drilled as close as possible to angles and welds.
All fixing holes should be used.
See also
Holes should be left for any areas that need ventillation.
The drilling holes should be perfect.
The holes should be directly under the knuckles of those two fingers.
The addition of hydraulic brakes and seat post holes should also be considered.
The holes should be big enough for the onions.
A gap between the shaft ends and the lower leg bolt holes should be visible.
These holes should be temporarily closed during metallization treatments.
Furthermore, the accessory holes should be equally spaced.
The holes should be there.
That is, indicate the distance at which the holes should be.
The holes should be about the size of a large pencil.
After the coring, the holes should be covered again.
The holes should be down and the cover facing you.
Prior to driving screws, pilot and clearance holes should be drilled.
Convection holes should be located just below the beveled plate.
When hollow metal profiles are used, all holes should be closed covered.
The holes should then be left alone until they are dry.
Detonators, other explosives and charged holes should not be left unattended.
The holes should be drilled in the center for maximum stability.
Optimally, the grout injected in adjacent holes should touch between them.
These holes should not fray the shell when stretched.
Effective particle spectrum, the nozzle holes should not exceed a certain diameter.
These holes should be about the same size as the bullet.
Secondly, he thought that no two consecutive holes should be played in the same direction.
Tooling holes should be placed at the corners of the board for locating.
As thermodynamical objects with non-zero temperature, black holes should emit thermal radiation.
The elongated holes should have a uniform width over their length.
Where to vent Within a compartment, all the vent holes should be at the same height.
The holes should be a bit deeper than the height of your stones.
All toilets should have doors, and toilet holes should be covered when not in use.
The pilot holes should be slightly smaller than the wood screws in diameter.
If Hawking is right, black holes should not actually be black.
The holes should be placed on the sides and the bottom of the container.
When drilling overhead, point B and the holes should receive the oil.
The ventilation holes should be kept away from anything that could stock it.
You'll also be interested in:
Examples of using Holes
Show more
Great holes have been cut in the earth
Always remove the lid or put holes in it
They cut holes behind every cabinet
