Examples of 'hop count' in a sentence
Meaning of "hop count"
hop count - In the context of networking, a 'hop count' refers to the number of routers through which a data packet must pass between a source and a destination. It is used to measure the distance or latency of a network route. A lower hop count usually indicates a more direct and efficient route
How to use "hop count" in a sentence
Basic
Advanced
hop count
It uses the hop count as metric in route selection.
Slow networks can be represented by a large hop count.
See also hop count.
Each terminal may be adapted to transmit information with a hop count.
It determines a route based on the smallest hop count between source and destination.
The information may be transmitted from the source terminal with a hop count.
On receipt of transmitted information the hop count may be reduced by one.
The Hop Count field is set to zero.
This is named the hop count.
RIP uses the hop count as the cost metric.
Hop Count The Hop Count is decremented by every router that forwards the Pip packet.
First of all, cost may be determined simply in terms of hop count.
Hop count from a router to a directly connected network is 0.
The correct value for hop count will be returned later, as described below.
Hop count as the measurement of cost, with a minimum of 1 for directly connected networks.
See also
It consists of the end-to-end hop count from a source to a destination over the network.
A hop count of 0 MUST be passed upstream unchanged.
The IP TTL is used, somewhat schizophrenically, as both a hop count limit and a time limit.
If the hop count for a path increases, the route is removed.
To maintain backward compatibility, the hop count limit of 15 remained.
The hop count 0 denotes a network that is directly connected to the router.
The mobile station 2d decreases the hop count of the received signal by 1.
Higher maximum hop count values would make the convergence time longer when count-to-infinity occurs.
The transmitted information may be re-transmitted if the hop count is non-zero.
Also, the hop count seemed to be higher.
In a step 60, the laptop 4 determines whether the hop count is zero.
Any hop count that is in excess of 15 is considered unreachable.
In a step 66, the mobile station 2d determines whether the hop count is zero.
The hop count can be a maximum, minimum, or exact hop count.
For example, the anchor node 1110 can transmit a discovered device request indicating a hop count of one.
Uses hop count as the measurement of cost, with a minimum of 1 for directly.
Each successive SN-LRU in the chain 311 increments the hop count accordingly.
In this example the hop count is zero, and the method ends in step 68.
The hop count can not exceed 15, or routes will be dropped.
When the first HC is greater than the preset hop count threshold, step 302 is executed.
As the hop count is now equal to 1, the method moves onto step 62.
The hop count can not exceed 15, or routes will be dropped . Most RIP networks are flat.
