Examples of 'incident energy' in a sentence
Meaning of "incident energy"
Incident energy: The total amount of energy per unit area surrounding a location due to an incident radiation or heat source. It is often used in the context of workplace safety to assess the potential hazards present
How to use "incident energy" in a sentence
Basic
Advanced
incident energy
It behaves as if the incident energy is completely absorbed.
Impact analysis of geometry on potential incident energy.
The incident energy is equal to the reflected energy.
This voltage of a few millivolts is proportional to the incident energy variation.
Calculated available incident energy and corresponding working distance.
Predictions of the dispersion of these peaks versus the incident energy were made.
Incident energy is the measure of the severity of the hazard to workers.
Induction heating gives rise to poor localization of the incident energy as well.
This indicates that all the incident energy is reflected and intensity is uniform.
The data obtained gives a precise estimate of the possible incident energy level.
Incident Energy is the energy profile when viewed through a thermal imaging camera.
This reflected energy now cancels the incident energy of the transmission line.
The duration of the arcing fault has a direct impact on the available incident energy.
This is the incident energy needed to cause a second-degree burn.
These two materials have then a comparable permeability to electrons of the same incident energy.
See also
Incident energy calculations ( arc flash ) and installation of identification tags.
A fuse with a faster tripping time would also reduce the level of incident energy.
How can incident energy be reduced using existing protection devices?
This measurement makes it possible to characterize charge sharing and find the incident energy spectrum.
Every 5 years, the incident energy study is required to update of all equipment the plant.
The FET device normally has a very poor match and reflects much of the incident energy.
The incident energy is the energy needed for an arc flash to cause second-degree burns.
In this case, the transformer becomes overloaded and the incident energy level increases.
Electrical safety, Incident energy at the exit of transformers.
The calorific energy may amount to up to 50 % of the incident energy.
A very small part of the incident energy Ei is transmitted to the output connection 6.
Consequently, they can not re-emit all the incident energy.
Incident energy without melting or vaporizing . Process settings that produce good results with alumina are.
What is the incident energy?
The incident energy in the event of an arcing fault would be reduced by 62 %.
This difference of 20 volts greatly increased the level of incident energy.
The Available Incident Energy and the corresponding working distance, or.
This index will be chosen to facilitate transmission of the incident energy between layers 30 and 31.
Figure1, Incident energy level at the output of transformers.
One of the units used to measure incident energy is calories per centimeter squared . ( cal / cm ² ).
All of the incident energy is reflected towards facet 21B.
Energy Breakopen Threshold ( EBT ) The incident energy on a material that results in a 50 % probability of breakopen.
What 's an incident energy study?
You'll also be interested in:
Examples of using Energy
Show more
Final energy consumed by road motor vehicles
To give attention and energy to everyday life
Energy efficiency and renewable source of energy
Examples of using Incident
Show more
Provide incident management and investigation services
Keep this unfortunate incident to ourselves right
The incident may be too trivial to recall
