Examples of 'initial viscosity' in a sentence
Meaning of "initial viscosity"
initial viscosity: a term used in physics or chemistry to describe the thickness or resistance to flow of a fluid at the beginning of a process
How to use "initial viscosity" in a sentence
Basic
Advanced
initial viscosity
A substantial reduction in initial viscosity is also ascertained.
The initial viscosity is close to that of water.
This is attributed to the low initial viscosity of the mixture.
The initial viscosity was then recorded.
Preferably the enzymes are added in mixing to breakdown initial viscosity.
The initial viscosity of each composition is also given.
The results are shown as a percentage of the initial viscosity over time.
An oil with a high initial viscosity will be more sensitive to this phenomenon.
The change in viscosity with increasing concentration is shown as a percentage of the initial viscosity.
The low initial viscosity ensures that the fibers are rapidly embedded.
Cements with a fast setting time and low initial viscosity are particularly well adapted.
It is found that the treatment of solution A causes a large decrease in the initial viscosity.
The invention provides methods of reducing the initial viscosity of a dietary fiber composition comprising glucomannan.
At this point, the viscosity is lower than the initial viscosity.
The initial viscosity n 0 of the solutions is measured before placing in the oven.
See also
At rest, the substance reverts to its initial viscosity.
The initial viscosity measurement is taken approximately 30 seconds after mixing is completed.
Irreversible viscosity change is expressed in percent of initial viscosity in steps of 5 %.
Compared with rubber, the initial viscosity of acrylic adhesive is relatively low.
In some embodiments, the final viscosity is greater than the initial viscosity.
Good balance of glass strength, initial viscosity and shear strength.
The initial viscosity reading is taken at 3 minutes into the measurement and recorded.
The apparently irreversible viscosity change is expressed in percent of initial viscosity in steps of 5 %.
Often this is seen as a large initial viscosity loss, followed by gradual further loss.
Immediately after the second blade, the viscosity increases, but not to its initial viscosity.
If the initial viscosity is too high, this would impede aeration, leading to lower overrun.
Figure 1 plots the effect of guar gum level on the initial viscosity of the prototypes.
Increased levels can reduce the initial viscosity and extend the stability period as composition 2 demonstrates.
Viscosity of these stirred samples was compared to their initial viscosity Bf20 before storage.
Finally, initial viscosity at Tm is determined by using these parameters.
The viscosity indicated in Table 1 is the initial viscosity after mixing.
Initial viscosity is defined as the Brookfield viscosity measured within 35 minutes of making the sample.
Concerning fluidity, it also showed a low initial viscosity and excellent viscosity stability with time.
Initial viscosity was tested using a 2EZ cup.
Figure 1, Effect of guar gum level on the initial viscosity of the meal replacement prototypes.
Viscosities of ceramic-waste liquors depending on variations in additive concentrations Additive Hardness Concen . Initial Viscosity.
N o, initial viscosity of solution.
The results are the following, Initial Viscosity.
The initial viscosity and thixotropic values are detailed in Table-3.
Also, the maximum viscosity value is at least 10 times higher the initial viscosity value.
The first composition had an initial viscosity of 670 centipoise at room temperature.
The viscosity decrease was at least 10 % of the initial viscosity.
The fourth composition had an initial viscosity of 350 centipoise at room temperature.
The initial viscosity is 62 Pa. s, and this then rises in the following manner,.
They were tested for shelf stability by noting the initial viscosity and viscosity after 121 days.
The initial viscosity of the paint was 25 sec Zahn 2 viscosity cup.
The polymer composition with IPA had an initial viscosity of 67 cps.
By this means the initial viscosity of the suspension is obtained at T=0.
Variation of the relative viscosity ur with respect to the initial viscosity ur0 measured at 30 ° C.,.
The initial viscosity was set at 15 sec., measured with the help of a DIN cup 4.
You'll also be interested in:
Examples of using Initial
Show more
The initial toxicology report came back
Objectives for this initial stage would be
Initial installation after all wiring is completed
Examples of using Viscosity
Show more
High viscosity materials applied without problems
Effects of polysaccharides on viscosity in the rheology of foods
Its viscosity lets an unctuous consistency reappear
