Examples of 'injectability' in a sentence
Meaning of "injectability"
Injectability (noun) - a term used in pharmaceuticals and medicine to describe the ease with which a substance can be injected, often referring to the properties of a solution or medication
Show more definitions
- The quality of being injectable.
How to use "injectability" in a sentence
Basic
Advanced
injectability
Injectability is also important for clinical uses.
Injectable suspensions having improved injectability properties.
Injectability screening was conducted on these microparticle formulations.
All the emulsions showed acceptable injectability.
Injectability is explained by the rheological properties.
Preparation of injectable suspensions having improved injectability.
The flow volume characterizes injectability as a function of time.
Injectability of small particle size fractions of microparticle formulations.
It is found that both cements have a good injectability.
Injectability testing and test criteria.
Injectable compositions having improved injectability.
This test determines the injectability of dilute biopolymer solutions.
This gel formation reduces syringability and injectability.
Injectability refers to the performance of the suspension during injection.
Formulation rheology and injectability.
See also
Injectability screening was conducted.
The compositions of the present invention have good injectability.
The injectability properties of various cement grouts can thus be determined.
This material is characterized in terms of its injectability and its development.
In vivo injectability failures are typically not predicated by laboratory or other in vitro testing.
G of the wort were sampled for the constant rate injectability test.
The injectability is explained by the unique rheological properties of plant derived fibril cellulose.
A pH reducing component can be added to the inventive composition to increase its injectability.
This test permits the determination of the injectability of dilute solutions of the biopolymer.
Injectability testing was carried out at each set of test conditions using triplicate trials.
Stability of the articles is a critical factor for the injectability of the formulation.
The injectability of risperidone microparticles was evaluated in Yorkshire weanling pigs.
These are not typically characterized by dimpling but have advantageous flow and injectability properties.
In vivo Injectability.
Surprisingly, coloring is usually indicative of poor injectability.
Injectability curve at constant flow-rate.
The polymer matrix promotes shear thinning and improved injectability of the depot composition.
Injectability results of surfactant and non-surfactant compositions.
In specific situations, the injectability of seams allows adequate flows.
As previously discussed, this can lead to problems with injectability.
Table 3 below summarizes injectability data for microparticles fractionated by size.
At this point, the sample was ready for injectability testing.
Table 3 bellow summarizes injectability data for microparticles fractionated by size.
Injectability testing of microparticle formulations prepared with a model drug, nalmefene base.
Storage capacity ' means any combination of space, injectability and deliverability.
Injectability is commonly a target property when developing hydrogels, assuring its administration in a minimally invasive procedure.
We have found three methods to improve injectability and / or to maintain injectability of particulates.
All mixtures had a good mouldability, a low stickiness, and a good injectability.
These results are marked improvements over the injectability of the un-blended microparticle compositions.
As noted above, the primary utility of the coated microcrystal is its injectability.
Particularly, the in vivo studies showed a dramatic improvement in injectability with increased injection vehicle viscosity.
Thus, injection force can be used both as a measure of viscosity as well as injectability.
The injectability results are shown below in Table 5.
For example, glycerol may be added to enhance the extrudability or injectability of the composition.
The injectability results are shown in Figure 3.
