Examples of 'injection hole' in a sentence
Meaning of "injection hole"
The term 'injection hole' is a medical or technical jargon that refers to the point of entry for a needle during injections or medical procedures
How to use "injection hole" in a sentence
Basic
Advanced
injection hole
A fuel injector comprises an injection hole and a valve body.
The plastic material will then be injected through a central injection hole.
This is because clogging of an injection hole with generation of metal soap is avoided.
Then you will get the exact size of the injection hole.
Each injection hole is temporarily plugged following its detonation and coal removed.
Sealing off definitively the electrolyte injection hole and the lateral hole.
The width of the injection hole is gradually narrowed inward at a predetermined contained angle.
A foaming agent is injected into the cylinder through an injection hole by means of a pump.
The injection hole 7a has a diameter preferably smaller than one millimetre.
The presence of this cylindrical duct facilitates forming an injection hole of very small diameter.
The injection hole 25 is made in the shell element 19 in an approximately radial direction.
The thus deposited smoke may cause clogging of the injection hole in the addition valve.
The injection hole 118 is located in the protuberance of the block.
This causes the needle to lift largely and fully open the fuel injection hole.
Several injection devices seal the injection hole after injection to prevent leakage and contamination.
See also
Thus, it will subsequently be possible to reuse the same injection hole if necessary.
An injection hole 34b is formed inside the annular groove 54 for injecting the grease.
Thus, accumulation of deposits at the injection hole of the in-cylinder injector is prevented.
In operation, waterwas injected into the cylinder through the injection hole.
Therefore, accumulation of deposits at the injection hole of the in-cylinder injector can be suppressed.
The second 6 inch injection borehole is then prepared like the first injection hole.
Fig . 18 is a view showing an injection hole film rewelding process.
The mould is now closed and injection can take place through the injection hole 35.
It 's the injection hole.
The torpedo itself has a tapered conical point 4 ending very close to the injection hole 5.
Fig . 15 is a view showing an injection hole film piercing process.
Figure 47 illustrates a supporting post and an adhesive injection hole.
The holder 18 was mounted in the injection hole to airtightly seal the cylinder 14.
The holder 18 was arranged so as to be detached from the injection hole.
Once the component is filled, the injection hole 354 may be closed off.
At the fuel injection hole 9 side from the needle valve 8 is formed a nozzle chamber 11.
Figs . 2 and 3 depict examples of the gas injection hole arrangement.
A connection member injection hole 732a may be defined in an edge of the corner connection member 732.
A gas for thermal insulation may be injected through an injection hole 679.
The injection hole 222 may be long in a direction along which the discharge parts 210 are arranged.
First of all, the operator has proceeded with drilling an injection hole 32 of a determined diameter D 0.
Then, the ink pump is operated to inject ink into the ink injection hole 270.
The gas is injected through the injection hole 676 from the outside of the outer spacer 67.
The thickness of the spray is limited by the height H " of the injection hole 74 ".
The cross section of the injection hole 36 is shown in FIG . 6.
You'll also be interested in:
Examples of using Hole
Show more
So does that giant hole in the wall there
The hole of the steam spout is clogged
Cut the piping hole sloped slightly
Examples of using Injection
Show more
Injection is electronically controlled via a common rail
Estimating vaccine and injection material needs
Skin injection hazard risk of explosion or fire
