Examples of 'injection speed' in a sentence
Meaning of "injection speed"
Injection speed: The rate at which a substance, such as a medication or fluid, is administered into the body using a syringe or needle
How to use "injection speed" in a sentence
Basic
Advanced
injection speed
Adjustment of injection speed to modify injection force.
Needleless syringe with two injection speed levels.
Maximum injection speed was also used.
The shear rate is proportional to the injection speed.
Shows effect of injection speed on viscosity.
A further object is to provide such an autoinjector with controlled injection speed.
Increase the injection speed.
The injection speed can be about one millimeter per second.
A continuous injection with a substantially constant injection speed is preferred.
Optimization of injection speed to remove turbulence due to air entrapment.
A channel is typically dimensioned to maintain a desired pressure at a particular injection speed.
Improve the injection speed and injection force control.
This provides a regulated system that controls injection speed as well as possible.
Molding injection speed is dependent on the flow rate of the compositions.
Reducing the section of the orifice increases both the injection speed and the pressure difference.
See also
Injection speed affected injection force in a protein concentration - dependent manner.
Effect on injection force by injection speed was also affected by particle size.
The speed should be equal, at this moment, at least to the required injection speed.
The current injection speed ( medication flow rate ) is shown.
The actual practice of determining the injection speed in production,.
A standard infusion / injection speed of 1 ml / min was used throughout the tests.
Generally speaking, higher injection pressure and injection speed are required.
The injection speed should be approximately 1 mL per 10 seconds for most vaccinations and medications.
This allows a much higher injection performance, injection speed and dynamism.
The fuel injection speed is also about 40 m / s.
With the above mentioned conditions 5 plaques with different injection speed were produced.
The air injection speed in the furnace is about 40 m / s.
Figure 8B depicts a cylindrical shape 817 that results if the injection speed is too slow.
The water injection speed is between approximately 8 and 9 m / h ;.
Injection speed was dose within 15 seconds.
The injection speed is between 5 and 50 % of the nominal speed.
You'll also be interested in:
Examples of using Injection
Show more
Injection is electronically controlled via a common rail
Estimating vaccine and injection material needs
Skin injection hazard risk of explosion or fire
Examples of using Speed
Show more
The speed of the vacuum source shall be
I must have hit speed dial by mistake
Zoom speed is determined by the amount of rotation
