Examples of 'input signal level' in a sentence
Meaning of "input signal level"
refers to the strength or magnitude of an electrical or digital signal that is being received or processed. It is often used in the context of audio or video equipment, telecommunications, or electronic systems
How to use "input signal level" in a sentence
Basic
Advanced
input signal level
Input signal level is too high.
Adjusting the input signal level.
Input signal level is very low.
When these LEDs flash reduce the input signal level.
Specifies the input signal level at which compression begins to occur.
Press the SeTuP button to monitor the input signal level on the displays.
Indicates the input signal level to the DAB module in block format.
When this LED flashes reduce the input signal level.
Displays the input signal level in dBFS Output Meter.
The INPUT control is used to adjust the input signal level.
In this case, the input signal level must be reduced.
Use the INPUT LEVEL control to adjust the input signal level.
The input signal level can be set with a dedicated Attenuation-control.
This LED illuminates green to indicate an input signal level is present in the channel.
The gain shall be sufficient to permit full-scale display for full-scale input signal level.
See also
CLIP LED indicates the input signal level is too high.
Input buffer 22 is designed to cope with the above variation in input signal level.
The TAPE IN control adjusts the input signal level of the TAPE IN jack.
This control adjusts the volume level of the PSA1 relative to the input signal level.
Level indicator, Set your input signal level this should illuminate on your loudest / lowest notes.
If this happens, reduce the input signal level.
Is the input signal level low?
Brightness is set at fixed level, regardless of input signal level.
However, the input signal level can not be set below the minimum level of 20.
The CLIP LED lights up when the input signal level is too high.
The input signal level was held constant at -28dBm.
This parameter enables you to adjust the input signal level in 6dB steps.
Lights when the input signal level is lowered to reduce distortion ( page 79 ).
In Total Bypass mode, the LED METER displays the input signal level.
Set the lower limit for the input signal level displayed in red with “ 3 colors ”.
Thus, advantageously, T can be set, even without a known input signal level.
Input 2 Gain - Adjusts the input signal level for channel 2.
Decoding performance is less than 10-2 Bit error rate with 0dBµV input signal level.
The input signal level for the 0 - X1 input signal interval equals to the Y1 value.
Low level “ I ” is indicated on a filter but the input signal level is correct.
Signal / Peak LED, This LED turns green when an input signal level over -30dB is present.
You'll also be interested in:
Examples of using Signal
Show more
Give me a signal when you want me to start
You have to use one signal at a time
Signal strength indicating connection between units
Examples of using Level
Show more
The deepest level is usually the first
Automakers took the fight to a new level
Check oil level and fill if needed
Examples of using Input
Show more
Do not use damaged input or welding cables
The input and output pairs are parallel
Select the desired input source correctly
