Examples of 'intake pressure' in a sentence
Meaning of "intake pressure"
intake pressure ~ the force per unit area exerted on the intake system of a machine or device, typically measured in pounds per square inch (psi)
How to use "intake pressure" in a sentence
Basic
Advanced
intake pressure
A difference between intake pressure levels is computed.
This permits the piston to be pressurized to the intake pressure.
This intake pressure is called boost.
This makes it possible to adjust a boost pressure or intake pressure.
A set value of an intake pressure will be explained first.
The hydraulic pressure changed according to engine speed and intake pressure.
The intake pressure of the compressor 1 is controlled by the rotation speed of the compressor 1.
Restricting the opening of the intake throttle causes intake pressure to drop.
Here, the intake pressure means the loaded condition of the engine, such as throttle opening.
The exhaust pressure will therefore be higher than the intake pressure created.
Therefore, in the intake pressure control method shown in Fig.
Take the possibility of increased altitude where there will be reduced air intake pressure.
In other words, the motor 1 here is at the intake pressure of the motorcompressor unit.
Control of the intake pressure is performed by controlling the throttle actuator ( PA ).
The computed fuel injection amount Q decreases as the intake pressure PM decreases.
See also
This decreases the intake pressure of the intake passage 17.
Figure 1, Influence of methylsiloxane on the rheological parameters of flow limit and intake pressure loss ;.
Pressure pick-up, especially for measuring the intake pressure of internal combustion engines.
If necessary, intake pressure is reduced by controlling opening of the intake throttle valve 23.
The term " intermediate pressure " denotes a pressure between the intake pressure and the discharge pressure.
Reduce the intake pressure ( Pz ) to a third of the maximum supply pressure.
The engine comprises means 46 b for measuring the intake pressure which is located in plenum 26 b.
An absolute intake pressure ( PBA ) sensor 7 is provided immediately downstream of the throttle valve 3.
As the rotating speed of the turbine 21 increases, the intake pressure reaches its target value.
A difference between the intake pressure levels is computed, and processing proceeds to step S29.
The increase in turbine speed is accompanied by a rise in intake pressure ( Block B8 ).
Therefore, the intake pressure is high.
The intake pressure sensor 42 detects pressure in the intake passage 22.
Many heavy-duty vehicle engines require that the intake pressure of natural gas be around 100 psig.
Adm, Intake pressure set point.
The pressure sensor 38 detects an intake pressure PM of the engine 3.
L-sp ˜ intake pressure set point value.
A pressure check valve 67A connects the intake pressure passage 61A and a pressure passage 65A.
An intake pressure sensor 55 detects the pressure at the output port of the VSV 54.
A similar intake pressure passage 61B is provided for the pump chamber 56B of the cylinder 54B.
You'll also be interested in:
Examples of using Pressure
Show more
No effect on blood pressure or pulse rate was observed
Pressure transmission pipe in the combustion chamber
We were under a lot of pressure because of the family
Examples of using Intake
Show more
Remove the intake grille by pulling it outwards
Check to see if the air intake is obstructed
The air intake must not be covered
