Examples of 'intake stroke' in a sentence
Meaning of "intake stroke"
intake stroke: In an internal combustion engine, the intake stroke is one of the four stages in the engine cycle. During this stroke, the piston moves downward, drawing a mixture of air and fuel into the combustion chamber to prepare for the combustion process
How to use "intake stroke" in a sentence
Basic
Advanced
intake stroke
The fuel is injected in the intake stroke.
An intake stroke followed by an evacuation stroke is here referred to as a cycle.
A position at any point on the intake stroke.
This ends the intake stroke and starts a compression stroke.
The fuel is injected during the intake stroke.
This part of the intake stroke in question can be varied from cycle to cycle.
The fuel injection timing is not limited to the intake stroke.
An intake stroke executed with a closed inlet valve is referred to as a closed intake stroke.
Then a new operating cycle starts with the intake stroke.
The intake stroke ends when the piston is at the BDC.
The intake valve was opened by the suction caused by the intake stroke.
During the intake stroke of Fig.
The intake valves also close earlier during the intake stroke.
Intake stroke - Air and vaporised fuel are drawn in.
The time at which the fuel is injected need not be in the intake stroke.
See also
When the intake stroke is completed, a travel limit sensor 441 triggers the motor to change direction.
A common feature for displacement compressors is that a volume is expanded during an intake stroke.
This two-stage intake stroke creates the so-called " fifth " stroke that the Miller cycle introduces.
A second injection is conducted later than the first injection and during the intake stroke.
During the intake stroke of piston 22 the intake valve 16 closes at point x sealing cylinder 7.
Further, the piston moves down in the intake stroke.
At this point, the intake stroke ends and the exhaust stroke of Fig . 16 begins.
This mechanism prevents fuel consumption during the intake stroke of " miss " cycles.
FIGS . 28A to 28C show the metering sub-system during a valve state change after an intake stroke.
A port injection system injects fuel just prior to the intake stroke ( outside the cylinder ).
During the remaining cycles / revolutions, gas is supplied during the intake stroke.
At this point, the exhaust stroke is complete and a new intake stroke may begin.
The pumping of air into and out of boot 12 begins as an intake stroke.
Detection window NW3 corresponds to a period in the intake stroke.
As in HCSI, HCCI injects fuel during the intake stroke.
Why is that? the reason, so the air can enter maximally when intake stroke.
FIG . 10 is a cross sectional view of the pump housing after the intake stroke.
The fuel is injected into the cylinder 1040 in the intake stroke.
Fig . 3A shows the flow in the cylinder 11 at an early stage in the intake stroke.
Fig . 3B shows the flow in the cylinder 11 in the latter half of the intake stroke.
FIG . 8 depicts the reservoir valve open state ( 1 ) before the start of the intake stroke.
You'll also be interested in:
Examples of using Stroke
Show more
She could stroke out at any second
Blades cut on the draw or back stroke
One stroke down on the final hole
Examples of using Intake
Show more
Remove the intake grille by pulling it outwards
Check to see if the air intake is obstructed
The air intake must not be covered
