Examples of 'intensity values' in a sentence
Meaning of "intensity values"
intensity values: Refers to the measure, level, or degree of strength, force, or significance assigned to specific data, variables, or attributes
How to use "intensity values" in a sentence
Basic
Advanced
intensity values
Intensity values are not ascribed to tornadoes or waterspouts.
Heart rate and exercise intensity values.
The total intensity values were subsequently calculated.
Antibody pairs with no corresponding intensity values are flagged.
Total light intensity values were measured by single determinations.
Antibody pairs for which there are no intensity values are flagged.
Light intensity values are in arbitrary units.
A baseline transformation was applied on intensity values before representing data.
The intensity values of the labeled bases are reported on a graph.
This range is represented by minimum and maximum intensity values.
The luminous intensity values produced shall then be corrected.
And spread them out over all possible intensity values.
The mean fluorescence intensity values are depicted in the figure.
Intensity values for all harmonics were recorded for each individual sample.
Correlation between blocking buffer intensity values and average intensity.
See also
Several intensity values are then determined from this vector.
Difference between the maximum and minimum intensity values of the utterances.
Imports color intensity values for points in the scan file.
The result of pointing automatically to the maximum of the intensity values is shown.
Intermediate color or intensity values correspond to progressing levels of grey.
Specifies the color mapping scheme for shading intensity values on point clouds.
The fluorescence intensity values are then normalized to the value at lowest pH.
Need to increase compensation in order to regain the intensity values of initial fluorescence.
Mean fluorescence intensity values after subtracting background fluorescence are shown.
Shows the colors that will be used to shade intensity values on point clouds.
Storing the measured intensity values of step b in a permanent digital memory.
The average intensity value is subtracted from each of the pixel intensity values.
Are the intensity values for the pixels of the image preceding or succeeding x.
Histograms were draw from and median fluorescence intensity values were determinated on gated population.
The staining intensity values of pixels in a digitized image can be plotted in a histogram.
The combination can be a straightforward addition of pixel intensity values along the column.
The relative intensity values may vary remarkably because of different orientation of crystals.
Histogram equalization accomplishes this by effectively spreading out the most frequent intensity values.
This memory area holds intensity values for all the screen points.
The intensity values from all the calibrators were used to generate a calibration curve.
The intensity value for each pixel is then compared to the mean intensity values.
The intensity values were obtained by peak fitting after subtraction of the background signal.
The first message contains a reception request for the intensity values measured by the second modules.
Intensity values are a measure of the effect of the antibody and tracer reacting together.
Table II sets forth the actual intensity values that were detected.
The pixel intensity values determined in this manner are used in the final composite image.
Shown are the Geometric Mean of the fluorescent intensity values obtained.
Intensity values of each cluster was averaged over the two replicates per coffee sample.
Data analysis by GCOS used both PM and MM intensity values with background subtraction.
The light intensity values are much lower than the maximum achievable light intensity values.
This done, the fluorescence intensity values will be stabilised.
The mean intensity values for the reference image are then assigned as reference intensity values.
Background-subtracted fluorescence intensity values are shown.
Results were fluorescence intensity values for each samples plotted against the identities of the samples.
Figure 5 a graph of a linear weighing function based on intensity values.
You'll also be interested in:
Examples of using Intensity
Show more
Maximum intensity if all lamps together are lit
Burns with the same intensity as sunlight
Minimum intensity if either lamp has failed
Examples of using Values
Show more
The measured values shall be plotted on a graph
Date and time revert to default values
Carrying values and estimated fair values
