Examples of 'jumper wire' in a sentence
Meaning of "jumper wire"
jumper wire - A jumper wire is a short wire used to complete an electric circuit or connect two points together temporarily
How to use "jumper wire" in a sentence
Basic
Advanced
jumper wire
Connect the jumper wire to the common lug.
Do not create a short between battery terminals with a jumper wire or tools.
Remove the jumper wire and retighten the connections.
Flip the switch with the jumper wire to the.
The jumper wire should not remain in contact after being cut.
Momentarily short across red and white terminals with jumper wire.
Do not remove the jumper wire unless connecting a rain sensor.
The first bypass circuit is connected to the outside and inside of the jumper wire.
Red jumper wire.
The two screws should then be loosened and the jumper wire removed from the board.
This jumper wire is included in the delivery scope of the touch operating unit.
This function can be deactivated if the jumper wire is reinstalled on the outdoor unit.
Disconnect the seat switch and temporarily connect the two terminals with jumper wire J as shown.
Remove the black jumper wire from the heating element and discard wire.
Systems not equipped with control device TR jumper wire installed.
See also
Check the JPBM jumper wire on the sauna power supply unit must be attached.
Male terminal spade Red jumper wire.
Remove the red jumper wire between terminals Rc and Rh.
Disconnect all wires from the high-limit switches except the short jumper wire.
Factory installed jumper wire between the RH and RC terminals must remain in place.
To test operation, disconnect the Sensor and connect a jumper wire between the Rain Sensor terminals.
Remove the yellow jumper wire from the terminals marked RAIN SENSOR on the terminal block.
If there is no neutral switch, jumper 4 and 5 with a short jumper wire.
There should be a jumper wire between input NC and input C.
Jumper wire used on old thermostat?
Attach the neutral ground jumper wire ( white ) to the cabinet with the green ground screw.
If water pipes are used to ground electrical system, appliances, or phone, install a jumper wire.
Remove the red jumper wire as shown in Figure 3 and discard.
With these connections made there are redundant circuits between the cable 70 and the jumper wire 76.
If no Rain Sensor is installed, the jumper wire may be damaged or missing.
The red jumper wire between Rh and Rc terminals must be removed in a 5-wire installation.
Connect the two yellow Rain Sensor terminals with a short length of 14 to 18 gauge jumper wire.
Check the JPSL jumper wire on the sound&light power supply unit.
To check vacuum switch, short across “ B ” terminals with jumper wire.
Make a jumper wire connection to receiver terminals 1 and 3.
To disable the time-out function, install a jumper wire in the area marked J1 on the PCB.
Remove the jumper wire and retighten the connections see Figure 12.
Therefore, the terminal block 33e and the terminal block 33c are connected through a jumper wire.
NEVER place a jumper wire across terminals to " cutout " the control.
After unplugging the unit, locate the jumper wire ( J-18 ) on the bottom of the control panel.
You'll also be interested in:
Examples of using Jumper
Show more
I will finish the jumper in four days
No jumper call came through our switchboard
Better get those jumper cables ready
Examples of using Wire
Show more
Steel wire liners can be coated or noncoated
Use a passage aid wire or previous cord
Cut wire liner at the right length
