Examples of 'junction box cover' in a sentence
Meaning of "junction box cover"
refers to a protective cover used to enclose and safeguard the electrical connections within a junction box
How to use "junction box cover" in a sentence
Basic
Advanced
junction box cover
Place the junction box cover in place.
Install strain relief onto junction box cover.
Remove junction box cover from exhaust unit.
Remove ventilator junction box cover.
Secure junction box cover with original screws.
The upper part is referred to as the junction box cover.
Replace the junction box cover on the dishwasher.
Plug in fan and heater assembly to receptacle in junction box cover.
Replace the junction box cover.
Install strain relief onto the knockout of the junction box cover.
Remove the junction box cover.
The junction box cover / heater assembly consists of two parts.
Reinstall the junction box cover.
Replace junction box cover in heater housing when wiring is complete.
Make sure to keep the junction box cover you removed.
See also
Remove junction box cover and knockout on the top left side.
Be sure wires are not pinched Secure junction box cover with original screws.
Remove junction box cover and retain for later use.
Remove the 6 screws on the junction box cover.
Remove the junction box cover and the selected knockout.
Remove the pre-attached Screw ( DD ) holding the junction box cover.
Remove junction box cover and pull house wiring into junction.
Make sure that the junction box cover is resting on the mounting bracket.
Remove junction box cover and desired knockout from junction box in housing.
Open the motor junction box cover located on the side of the motor.
Return the junction box cover to its original position and secure with the original screws.
Replace the oven-mounted junction box cover and tighten the two screws holding it in place.
Remove the junction box cover and then install the strain relief.
Remove the junction box cover from the junction box inside the cabinet.
Remove the lower junction box cover by squeezing sides together and pulling off.
Remove the junction box cover at the end of the baseboard you wish to wire.
Secure the junction box cover with the 2 original screws.
Remove the junction box cover / heater assembly from the back box by removing 8 screws.
Locate junction box cover set aside in Step 1.
Remove the Junction box cover and install the conduit connector ( cULus listed ) in junction box.
Remove junction box cover 4 screws.
Replace junction box cover 4 screws.
Install the junction box cover using 10 hex head screw.
Remove the junction box cover refer to Figure 5 on page 11.
Remove the junction box cover see Figure 5 on page 11.
Install junction box cover set aside in Step 1, using 10 hexhead screw.
Remove junction box cover, Figure 13, by lifting the junction box cover up and off.
STEP 17, iNSTALL juNCTiON BOx COVER If junction box cover is already installed, skip to Step 18.
You'll also be interested in:
Examples of using Cover
Show more
Remove the battery cover by sliding it downward
Cover and keep warm up to one hour
Unscrew the bulb cover by turning anticlockwise
Examples of using Box
Show more
Pull the box out as far as possible
You blind someone with that box
The box the vacuum cleaner came in
Examples of using Junction
Show more
The very junction of heaven and earth
Do not switch off the junction box
The junction box contains a safety switch
