Examples of 'knob must' in a sentence
Meaning of "knob must"
knob must: an incomplete phrase that may imply an action or requirement related to turning or adjusting a knob or control in a certain situation
How to use "knob must" in a sentence
Basic
Advanced
knob must
The knob must be released to activate the.
The temperature control knob must be on off position.
The knob must be released to activate the adjust mode.
The gas regulating knob must be in the position.
Knob must be freely accessible over its entire range.
The setting knob must be pulled out.
Knob must be tightened and safety pins engaged before use.
The thermostat knob must be pushed down as far.
Knob must be tightened completely and checked for tightness before each use.
During this time the control knob must be held down until the flame is burning.
This knob must be set according to the source volume line output level.
Arrows on the sprocket cover and tensioning knob must align before the cover is replaced.
The setting knob must be turned clockwise to the time required.
Humidifier must be powered and control knob must be turned to OFF position.
The wing knob must be tightened completely for the blower to operate.
See also
When using the STEAM function the regulator knob must be turned to STEAM.
The choke knob must engage in position.
In order to perform the above operation the steam / water knob must be closed.
The tensioning knob must be rotated counterclockwise to its stop.
Open the ball valve by turning the rinse knob o Rinse knob must be vertical 2.
The emergency knob must be set to the central position.
To perform the operations listed below, the steam / water knob must be closed.
The locking knob must be tightened during mitre cuts.
After the heating up phase, the knob must be set to the respective fuel.
The PTO knob must be in the “ disengaged ” position when starting the engine.
Before being used again, the control knob must be set to the off position.
The control knob must therefore be locked only in certain angular positions.
The FX On button under the knob must be lit for this knob to function.
Control knob must be in the “ OFF ” position Figure 3.
Note, Regulator / control knob must be removed before folding legs.
The thermostat knob must be pushed down as far as it will go when starting.
The index depth adjustment knob must be reset for each diameter of pipe / tube.
Upper guide lock knob must be tightened before the band saw is turned on.
To select Clean, the temperature knob must also be moved into the appropriate Clean position.
The PTO / Blade Engage knob must be in the disengaged ( OFF ) position when starting the engine.
To select Clean, the temperature knob must be moved into the appropriate Clean position too.
The Fuel Control Knob must be in the “ON” position for the engine to run.
The temperature control knob must be on off po-sition progress 23.
The thermostat knob must be on its minimum position ( MIN ), and.
The lug with a star knob must be located opposite to the side spout.
The emergency knob must be set to the CH position.
To change a setting the knob must be pushed against a spring, thereby disengaging a pinion.
Burner control knob must be in the “ OFF ” position.
