Examples of 'lead wires' in a sentence
Meaning of "lead wires"
Lead wires are electrical conductors that are used to connect various components or devices together in an electrical circuit. They are typically made of metal and have insulation to prevent short circuits or electrical hazards. Lead wires are commonly used in industries such as electronics, telecommunications, and electrical engineering.
How to use "lead wires" in a sentence
Basic
Advanced
lead wires
Oven main lead wires are colored as follows.
This unit has copper lead wires.
Do not solder lead wires or terminals directly.
A weak current flows in the lead wires.
Attach lead wires inside headshell properly.
Be careful not to damage the connector or lead wires.
Place the lead wires in the specified position.
Be careful not to damage the terminals or lead wires.
Lead wires or soldering legs are optional.
Avoid twisting the lead wires.
Both lead wires are wrapped with similar spacing.
Someone soldered the lead wires.
Check that the lead wires are inside the rib.
This loop is attached to two insulated copper lead wires.
Cartridge lead wires are loose.
See also
Protect the sensors and their lead wires from.
Do not insert lead wires into a mains power supply.
Check whether all electrodes have been connected to lead wires of patient cable.
Do not solder lead wires directly onto the battery.
The grommet is rubber and contains slits to receive the lead wires.
Measure between the lead wires of the SunStat sensor.
Lead wires were then fitted thereto to finish each capacitor element.
The yarn secures the lead wires to the insulator.
Lead wires were attached to the respective electrodes to complete a solar cell.
Small components have bare lead wires for soldering.
Do not solder lead wires or terminals directly onto a battery or modify it.
A lamp is positioned within the sleeve and includes lead wires coupled to the contacts.
Check that the lead wires are not trapped by the cover.
The terminals of cartridges and the Headshell lead wires are color coded.
Electrical lead wires were then attached to the remaining pair of conductors.
This significantly reduces the length of the lead wires of the feedback and control systems.
Wipe lead wires after use with a damp cloth or antiseptic wipe.
Always use the independent lead wires for the speakers to be used.
Examine lead wires before each treatment for loose connections or damage.
The connector was soldered to the lead wires and protected by a canvas jacket.
A pair of lead wires may be connected to the electrical contacts of the resistor.
The metal free zone limits the location of lead wires within the optical path.
Connect the lead wires to the junction box supply wires in proper phase.
Insert one of the AM loop antenna lead wires into the AM ANT terminal.
The lead wires are fitted with quick connect terminals for this purpose.
Reattach the motor lead wires as shown in Figure.
The lead wires at either end are factory spliced with wire nuts as a closed circuit.
The terminal polarity of the lead wires on the accessory headshell are shown below.
The lead wires may be attached by known wire bonding techniques to a conductive chip pad.
This allows fitting more lead wires per lumen fixed cross sectional área.
The lead wires connect the control unit and the electrodes and transmit the electric current.
Connect the Headshell lead wires to the cartridge terminals.
Lead wires cable suitable for connection with YCQB equipped with Packard connector.
Pull out the four lead wires from the cartridge itself.
Winch assembly with wire rope including lead wires 1.
You'll also be interested in:
Examples of using Lead
Show more
This would lead to better utilization of resources
But you gotta take the lead
Delay in treatment can lead to amputation or death
Examples of using Wires
Show more
Do not operate if wires and terminals are exposed
Wires can be difficult to see when flying
Connect house wires to ventilation fan wires
