Examples of 'leave a white' in a sentence
Meaning of "leave a white"
leave a white: This phrase is unclear and may need more context to provide an accurate definition
How to use "leave a white" in a sentence
Basic
Advanced
leave a white
It may leave a white cast on the skin.
The effect of saltpetre is to leave a white efflorescence.
They will leave a white residue on the leaves.
Evaporate the solvent to leave a white powder.
Does not leave a white residue on skin that you can see.
Marasmius funalis mushrooms leave a white spore print.
These products may leave a white residue which can be cleaned using the cleaning guidelines above.
Evaporate the solvent in vacuo to leave a white powder.
It will leave a white mark, so you can only use it at night.
The solvent was removed in vacuo to leave a white solid.
The alcoholic solution will leave a white residue of small crystals upon evaporation.
The solution was filtered and concentrated to leave a white solid.
Solvents were removed in vacuo to leave a white solid which was suspended in acetone.
The ethanol extract was evaporated in vacuo to leave a white solid.
He would leave a white marble and I would come and find him, no matter what.
See also
The remaining ether was removed under pressure to leave a white foam.
This sunscreen, however, can leave a white cast, especially if you are not rubbing it well.
Then the volatiles were removed by vacuum transfer to leave a white paste.
It's difficult to leave a White House.
The organic phase is dried, filtered and concentrated at reduced pressure to leave a white solid.
The residue was extracted with methanol to leave a white crystalline solid.
Active fractions from this column were combined and concentrated to leave a white solid.
Furthermore, it is non-greasy and does not leave a white film on your skin.
Unlike the creams that doctors prescribe, coconut oil is non-irritating and will not leave a white mess.
The filtrate is concentrated under reduced pressure to leave a white solid residue ( 0.50 g ).
The organic phase was separated and concentrated in vacuo to leave a white solid.
In this last picture, you can see that I voluntarily leave a white area on the mask.
After stirring for an additional 10 minutes, the solvent was evaporated to leave a white foam.
The solvent was removed from the filtrate to leave a white solid.
After stirring over night the solvents are evaporated to leave a white solid product.
Excess HCl was evaporated with methanol ( x3 ) to leave a white solid.
After 24 h the methanol was removed in vacuo to leave a white mass.
The product was dried under vacuum to p < 20 mtorr to leave a white powder.
Toluene ( 150ml ) was added and the slurry was re-concentrated in vacuo to leave a white solid.
