Examples of 'led flashes' in a sentence
Meaning of "led flashes"
Led flashes can refer to the blinking or flashing of light emitting diodes (LEDs), often used in electronic devices or as indicators in various applications
How to use "led flashes" in a sentence
Basic
Advanced
led flashes
The led flashes to indicate that computation is complete.
Filter cleaning warning led flashes.
The led flashes according to the code entry learned.
The musicbox is set on mute led flashes white.
The seventh led flashes when external messages are sent or received.
Briefly press the Bluetooth button led flashes blue.
After the series of led flashes the led will stay in a slow constant flash state.
Press the Bluetooth button on the musicbox led flashes blue.
At level 2 the OK Led flashes quickly while the INPUT Leds indicate the selected parameter.
Check that the Led flashes.
The led flashes for 15 seconds or until you press any currently activated key.
Power the control unit and check that the OK Led flashes rapidly for.
The failure led flashes in a code1.
Check correct operation of these types of photocells, ensuring that the relative Led flashes slowly.
The led flashes at the 100 ms rate for various cycles indicating system status.
See also
For 5 seconds until the led flashes on and off.
If there is a dead short in the cell for over 60 seconds the STANDBY led flashes.
Check that the OK led flashes regularly, with one flash per second Figure 25.
When you select the Normal Sequential Gearbox Mode, the led flashes green for a few seconds.
After 200 hours operation the Led flashes to indicate saturation of the Activated Charcoal Filters.
If there is a message in progress ( sending / receiving ), then the green led flashes every.
Visual diagnostics of the lockout condition, led flashes at 1 second intervals.
If you have reached the maximum configurable time ( 120 minutes ), the T led flashes rapidly.
If there is not enough signal strength then the red led flashes continuously every 300ms.
Press 2 to activate the “ Close after photo ” function now the Led flashes slowly.
After powering the control unit, check that the OK Led flashes at 1.
Note, - When the Precision Drive mode is enabled, the led flashes continuously.
Deactivate the “ opening delay ” function by pressing P2 now the Led flashes quickly.
If you have reached the maximum configurable time ( 120 seconds ), the T led flashes rapidly.
You'll also be interested in:
Examples of using Led
Show more
The highway led over mountains of dead
Led indications before connection to the battery
Your weakness led these souls to judgment
Examples of using Flashes
Show more
The battery icon flashes during charging
The flashes erase part of the shadow
The elapsed time flashes while paused
