Examples of 'leds will' in a sentence
Meaning of "leds will"
'LEDs will' is an incomplete phrase that lacks context to determine its specific meaning. 'LEDs' generally refers to light-emitting diodes, which are electronic devices that emit light when an electric current passes through them. However, without further information or a complete sentence, it is not possible to provide a specific definition or interpretation for this phrase
How to use "leds will" in a sentence
Basic
Advanced
leds will
The LEDs will change to indicate status.
The orange receiver LEDs will continue flashing.
The LEDs will remain on to indicate it is ready.
All three LEDs will blink.
The LEDs will indicate the status of charge.
And all the leds will turn off.
The LEDs will light up in the following situations.
Both blue LEDs will blink.
The LEDs will verify which source is selected.
The yellow status indicator LEDs will flash.
All zone LEDs will turn off.
During a fault condition all three LEDs will turn off.
All LEDs will flash three time.
One of the wash cycle LEDs will be flashing.
The LEDs will be switched off for.
The yellow and green LEDs will blink.
The LEDs will flash red once.
The blue and red LEDs will begin.
All LEDs will be lit during two seconds.
This is because LEDs will not.
All LEDs will turn off when discharging.
The blue and red LEDs will begin to flash.
The LEDs will be on in the following three conditions.
The device LEDs will light up.
The LEDs will now flash alternately at a slower rate.
Near to the poles the LEDs will be in staggered rows.
The LEDs will verify which input is active.
Once charging commences both LEDs will illuminate without flashing.
The LEDs will light up and fade out.
After one second both LEDs will flash one time.
All LEDs will flash briefly.
Release the button and all LEDs will flash once.
Green LEDs will show a realtime connection is made.
Allow the user to choose how many LEDs will be turned on.
The pad LEDs will show the recorded movement.
The temperature of the environment where the LEDs will be running.
The respective leds will light up on the blower.
If a hot battery is inserted into the charger both LEDs will illuminate.
The two outside LEDs will be flashing alternately.
When the synchronization becomes better the yellow LEDs will turn on.
The two red LEDs will start flashing.
The countdown display and one of the wash cycle LEDs will be flashing.
All seven LEDs will light up.
The LEDs will remain on to indicate it is ready to accept a new primary fingerprint.
All the coffee buttons and LEDs will blink once as confirmation.
The LEDs will flash throughout the setup process.
Once fully charged all four blue LEDs will light steadily.
The pad LEDs will remain lit at that position.
The yellow light indicator and the infrared leds will turn off.
The corresponding LEDs will indicate the activated function.
