Examples of 'lightly sand' in a sentence
Meaning of "lightly sand"
lightly sand: The act of sanding a surface gently or with minimal pressure to smooth it, remove imperfections, or prepare it for further finishing. This phrase is commonly used in DIY, woodworking, painting, and restoration contexts to describe a soft or delicate sanding technique
How to use "lightly sand" in a sentence
Basic
Advanced
lightly sand
Lightly sand the fuselage to correct if out of alignment.
Take your new wood moldings and lightly sand them.
Lightly sand the edge until it is smooth again.
Remove the stabilizer tube and lightly sand the outside of the tube.
Lightly sand the back of the instrument panel.
You can even very very lightly sand after the last coat.
Lightly sand and clean it right up.
For maximum grip, you can always lightly sand the surface.
Lightly sand the surface to create an aged look.
After that, it is best to lightly sand the wall and then dust it again.
Lightly sand the spot to be restored.
For a high gloss finish lightly sand between coats, excluding the final coat.
Lightly sand the surface of the wheel bed.
For best results, lightly sand surface.
Lightly sand the corners of the engine mounting box.
See also
So, just lightly sand.
Lightly sand the walls.
You may need to lightly sand away any raised wood grain.
Lightly sand the undercoat with a fine grade of paper before.
To remove scratches, lightly sand the blemish and then reapply the oil.
Lightly sand chair.
For best results, lightly sand wood surface before applying HERCULINER.
Lightly sand the tray as necessary so it fi ts tightly against the fuselage sides.
Once done, lightly sand the edges so that there is a smooth finish.
Lightly sand the wheel pant spacers in preparation for their installation.
Lightly sand the bottom of the fin or slot in the fuselage if necessary.
Lightly sand the opening in the fuselage to correct any alignment problems.
Lightly sand the elevator joiner wire where it contacts the elevators.
Lightly sand the tail gear wire where it will contact the rudder.
Lightly sand the bottom of the backrest with medium sandpaper to remove the paint.
Lightly sand the inside of the exhaust where the mount will contact the exhaust.
Lightly sand the joint areas of the ABS parts to roughen the surfaces.
Lightly sand imperfections in finished joints, corners and over fastener heads.
If not, lightly sand the blades where they contact the yoke to allow free movement.
Lightly sand the edges if you want to create a distressed vintage look… and you're done!
Lightly sand ( 240 grit ) both bonding surfaces of specimen and wipe clean with alcohol.
You'll also be interested in:
Examples of using Lightly
Show more
It could be a poem or a lightly choreographed dance number
Lightly grease the bottom baking sheet
Use for cleaning lightly soiled loads
Examples of using Sand
Show more
Sand or mud may cause irreparable damage
Do not grind or sand near flammable materials
Sand got there a few minutes before me
