Examples of 'line spool' in a sentence
Meaning of "line spool"
line spool - a cylindrical object around which material can be wound, such as thread, wire, or magnetic tape. It is often used in fishing or textile industry for efficient storage and deployment of the material
How to use "line spool" in a sentence
Basic
Advanced
line spool
Trimming around trees with line spool.
Only use line spool recommended by the manufacturer.
Low trimming with line spool.
Put the line spool in the spool housing.
Replace with a new line spool.
Line spool with cutting line.
Always keep the line spool parallel to the ground.
Line spool is not wound well.
Avoid touching small objects such as stones with the line spool.
Set the line spool to the required height.
Replace the bump knob by inserting it into the centre of the line spool.
The line spool is already fi tted when the equipment is delivered.
Remove the line head bottom and the line spool from the line head top.
Inspect line spool to insure that line is not overlapping or internally jammed.
Before you start the engine ensure that the line spool will not strike an obstacle.
See also
Always keep the line spool on the ground whilst the equipment is in operation.
Trimming / mowing cutting blade or line spool.
Never hold the line spool above knee height when the equipment is in operation.
Cutting along fences / foundations with line spool.
Keep the guard hood, line spool and engine clear of mowing debris at all times.
Cut off a maximum of 4 m from the cutting line spool.
The line spool has a bump-feed mechanism.
Do not use any wire, or anything similar in the line spool.
Press the release tabs on the line spool cover, as shown in.
Cutting against trees / fences / foundations with line spool.
To do so incline the cutting line spool at a 30 degree angle to the right.
Replacing cutting line / cutting line spool 1.
Replacing the line spool / cutting line - Dismantle the line spool.
Remove the line trimmer head cover, bump knob, and line spool and set aside.
Wear parts * Line spool holder Consumables * Line spool Missing parts.
The procedure for fi tting the line spool is shown in Figure 21.
Skip points 3-6 if you are replacing the entire line spool.
Angle the line spool 30 degrees to the right.
Press the spool plate into the line spool housing Fig . 36.
Your line spool for this product has two ( 2 ) wind areas for line.
Push the spool disc into the line spool housing see fi g. 12f.
Re-install the line spool see “ Installing / replacing the line spool ” chapter.
To do this, set the line spool at an angle of 30 to the right.
You'll also be interested in:
Examples of using Line
Show more
One in a long line of successful cop marriages
Select the data to display on that line
Those withdrawals are in line with international law
Examples of using Spool
Show more
Put a spool of thread on the spool pin
Check to see if the spool is properly wound
Move spool holder to remove both spools
