Examples of 'link-local' in a sentence
Meaning of "link-local"
Link-local is used to describe a type of network address that is only valid for communication within a specific network segment
How to use "link-local" in a sentence
Basic
Advanced
link-local
Link-local addresses are always configured automatically.
Most routing protocols use link-local addresses as.
This is a link-local scope multicast address.
An address specified as a next hop must be a link-local address.
A single link-local address is supported per interface.
All interfaces are required to have at least one Link-Local unicast.
Using the link-local address of the router.
Another type of private networking uses the link-local address range.
The presence of link-local addresses on all interfaces.
Any computer which supports IPv6 will automatically generate a link-local address.
Packets with a Link-Local source or destination address will not be forwarded to other links.
The used of prefix shows that this is a link-local multicast address.
With the exception of link-local addresses, address autoconfiguration is specified only for hosts.
Thus, this document intentionally focuses on link-local and multicast scopes only.
Packets with IPv6 link-local addresses can be forwarded only through a local link.
See also
Therefore, this document specifies encoded information for link-local scope in multicast addresses.
Nodes use link-local addresses to communicate with neighboring nodes on the same link.
Duplicate address detection is performed to verify the uniqueness of the tentative link-local address.
An encrypted connection between link-local devices, typically a wireless client and an access point.
Link-local and site-local multicast scopes span the same topological regions as the corresponding unicast scopes.
Routers must not forward any packets with link-local source or destination addresses to other links.
Nodes use link-local addresses when communicating with neighboring nodes on the same link.
MID is needed for multicast group knowledge that is not link-local.
An IPv6 link-local address can be used for communication between nodes on the same link.
The only exception is the Interface-Identifier for the link-local address used by the MS.
Link-Local addresses are for use on a single link.
By default, HA automatically chooses an internal interface and automatically assigns link-local IP addresses.
Link-Local addresses are designed to be used for addressing on a.
Multicast address, all nodes in link-local scope.
O Its required Link-Local address for each interface.
All interfaces of IPv6 hosts require a link-local address.
Link-Local multicast scope spans the same topological region as the corresponding unicast scope.
In IPv4, the method is called link-local address autoconfiguration.
The Link-Local Address is automatically populated.
An IPv6 device must have at least a link-local address.
The UE keeps the link-local address, and extracts the interface identifier for later use.
These are a site-local address and a link-local address.
Link-local addresses are used between on-link neighbors and for Neighbor Discovery processes.
Uses of link-local address.
Link-local addresses are a new concept in IPv6.
An IPv6 interface has at least one link-local address enabled.
Link-local addresses are something new in IPv6.
However, it is expected that routers will generate link-local addresses.
Link-local and global address.
The absence of routers, a host can only generate link-local.
However, link-local addresses are sufficient for allowing.
An IPv6 router never forwards link-local traffic beyond the link.
Link-local unicast addresses are private IPv6 addresses.
Except for virtual links, all neighbor exchanges use IPv6 link-local addressing exclusively.
Link-local multicast group address.
