Examples of 'main broom' in a sentence
Meaning of "main broom"
This phrase is used to refer to the primary or most important cleaning tool used for sweeping or cleaning floors. It suggests that there may be multiple types or sizes of brooms available, but the 'main broom' is the one commonly used or designated as the primary tool for the task
How to use "main broom" in a sentence
Basic
Advanced
main broom
Main broom height check and adjustment.
How to adjust main broom wear pattern.
Main broom adjustment and replacement.
Side and main broom condition.
Press the button again to deactivate the main broom.
Side and main broom height check.
Check the front and rear skirt of the main broom housing.
Assemble the main broom in the reverse order of.
For single pass sweeping the operator can simply lower the main broom.
The main broom is not correctly adjusted or is worn.
Check the correct position of the main broom in the following way.
Side and main broom height check and adjustment.
The machine should be stored with the Main Broom in the raised position.
Stop the main broom and move the machine.
Perform step 1 again to check that the main broom is at.
See also
The new main broom must be installed with the bristles.
Upwards, then lift it or lower it to change the main broom height.
Only the rear main broom touches the fl oor and wears.
Perform step 1 again to check the proper adjustment of the main broom height from ground.
The main broom has been preset at the factory for maximum sweeping efficiency.
NOTE, The machine should be stored with the Main Broom in the raised position.
The main broom can be easily replaced by removing three screws from each half.
Drive belt replacement, traction, main broom.
Pull the main broom out of the broom housing and remove any string or wire.
Drive belt visual inspection, traction, main broom.
Let the main broom run in place for 1 minute.
When turned to “ I ” the vacuum system and main broom.
The main broom stop must be re-adjusted when the broom is replaced.
Pay attention to the driving belt ( D ) of the front main broom.
Replace the main broom when the bristles are worn to 2 inches in length.
Right adjuster of the main broom height 24.
If the main broom is set too low, the sweeper will be hard to push.
Adjust the height of the main broom ( 9 ) with the two knobs 7.
Main broom height adjusting knob7.
Are turned on ; when turned to “ II ” the vacuum system, main broom.
To install the main broom, refer to Main Broom Maintenance paragraph.
To proceed, lift the cover in order to release the main broom safety device Fig . 21.
Left side main broom access panel2.
Close and swing the idler arm assembly ( C ) back into the main broom core.11.
Remove the main broom as shown in the relevant paragraph.6.
The main broom lift control ( W ) is located to the left of the driver 's seat.
You may operate the main broom in either the “ SWEEP ” or “ FLOAT ” position.
Main broom right door fastening screws 26.
Check the correct main broom height from the ground ( not carpet ), proceeding as follows.
Main broom height adjusting knobs15.
Put a new main broom in the broom chamber.6.
Check the main broom and it " track " you have collected wires, cables etc.
Turn off the main broom by pressing the switch ( 1 ), • then move the machine.
Remove the main broom ( F ) and keep screws, supports.
Install the main broom with the bristles as shown in H, • Fig . 1.
