Examples of 'mean surface' in a sentence
Meaning of "mean surface"
Mean surface refers to the average or middle-ground surface of an object or area. It is the calculation of the midpoint or equilibrium between the highest and lowest points on the surface, providing a representative value
How to use "mean surface" in a sentence
Basic
Advanced
mean surface
Mean surface fi nish of TableTop slatband chain.
Overall global annual mean surface temperature increase.
Mean surface area of the whole body.
And in the normal direction to the mean surface.
Mean surface roughness may be defined in different manners.
This is expected to continue as global mean surface temperatures increase.
Mean surface power density.
Sbody is the geometric mean surface area of the full body.
Mean surface area.
This axis is generally situated in close proximity to the mean surface.
Annual mean surface temperature changes based on linear trends.
Temperature at these depths is generally close to the annual mean surface temperature.
Mean surface area of the compartment in question in its largest dimensions.
The useful quantity can be equal to said mean surface flux of photons or electrons.
Mean surface roughness.
See also
This data was then extrapolated to zero to establish the mean surface pore diameter.
Mean surface temperature.
Arrows depict the seasonal mean surface wind regressed on the same time series.
This is a list of mountains on Mars by height above mean surface level.
Annual global mean surface temperature and anthropogenic radiative forcing.
The DI max is related to the mean surface área of the cells.
Meters over mean surface largely cinder and gypsum with some evaporite deposits.
So there is a lot of attention to Global Mean Surface Temperature.
The preoperative local mean surface refractive power is measured at the apex of the cornea.
The level z 0 corresponds with the mean surface elevation.
The mean surface area S of the body is the geometric mean of the inside surface.
Test piece surface condition recommended mean surface roughness Ra < 2 μm to minimize data scatter.
The mean surface temperature is 55 degrees Celsius.
The temperature of the global annual mean surface drops down by at least 26 degrees Celsius.
Mean surface area of the body Sm Si . Se.
In this new formula S ( geometric mean surface area ) is replaced by Sbody internal surface area.
The surface roughness value ( Ra ) is the arithmetic mean surface roughness.
The coefficient of mean surface loss by dividing Dt by the total loss surface S.
In a calorimeter box of mean surface area . m2.
This is just plot of mean surface brightness, with an effective radius, versus luminosity.
To balance this force, the mean surface increases - this is known as setup.
The mean surface dispersion was about 50 % less than the dispersion 1.5 m below the water surface.
This equation ( 4 ) is verified fcr any mean surface temperature in the case cf radiation.
You mean surface encounters?
I don't mean surface change.
However, the mean surface addition power does not exceed 0.25 D between these two portions.
Maximum terrain: 220 meters over mean surface largely cinder and gypsum with some evaporite deposits.
During summer, daily mean surface temperatures were initially less than air temperatures.
Maximum terrain 220 meters over mean surface largely cinder and gypsum with some evaporate deposits.
Evolution of the mean surface of the wound in different groups ( cm2 ) Day.
Geometric mean surface area, m2.
You'll also be interested in:
Examples of using Mean
Show more
I do not mean that your feelings are tiny
Fancy words that do not mean anything
The mean treatment duration was two years
Examples of using Surface
Show more
An uneven surface increases the risk of overturning
Where ϑ is the measured test surface temperature
All feasible surface and subsurface ECVs
