Examples of 'measurement cycle' in a sentence
Meaning of "measurement cycle"
measurement cycle: This phrase refers to the process or period of time during which measurements are taken, analyzed, and interpreted. It is often used in scientific, technical, or quality control contexts to track and evaluate data over a specific timeframe
How to use "measurement cycle" in a sentence
Basic
Advanced
measurement cycle
This measurement cycle is done twice per minute.
This concludes one exposure measurement cycle.
A typical measurement cycle is performed in fractions of a second.
In this mode there is only one measurement cycle.
This measurement cycle lasts a few hundred milliseconds.
Press again to resume a measurement cycle.
This measurement cycle takes place continuously as follows.
The frequency of repetition of each measurement cycle is variable.
The particle measurement cycle starts with calibration.
The result is obtained after conducting a measurement cycle.
Then a second measurement cycle is activated.
The table is updated upon each measurement cycle.
In terms of a measurement cycle or a measurement rate.
Actuation of the solenoid triggers the start of measurement cycle.
The whole measurement cycle takes less than a second.
See also
A sensing step is also carried out during the measurement cycle.
A complete measurement cycle requires about eight seconds of contact time.
Any error in charge estimation is rolled over to the next measurement cycle.
The measurement cycle can be repeated at several positions along the part axis.
The interference detector is reset before starting the sensor measurement cycle.
A complete measurement cycle may comprise one or more sets ofextraction and sensing.
The one or more microprocessors may be further programmed to control a measurement cycle.
Automatic zeroing after every measurement cycle ensures excellent stability and reliability of measurement.
An exact turbidity value is calculated from the four measured values of a measurement cycle.
In this example a measurement cycle includes obtaining analyte related reading from both sensors.
The first method concerns synchronizing the impedance measurement cycle on the recognized stimulation peaks.
The operation of the sonde described above will now be described during a complete measurement cycle.
Advantageously, the measurement cycle is performed repetitively, preferably periodically.
The Return Key is then pressed to begin the automatic measurement cycle.
However, the measurement cycle may be set in consideration of other situations.
Being in the order of about 2 minutes per measurement cycle.
The measurement cycle has a duration of 1 hour per analyzed sample.
The numbers n, d and c are constant during each measurement cycle.
A measurement cycle is initialized by a receiver change signal coming from the interface 15.
The numbers n, a and b are constant for each measurement cycle.
First, the measurement cycle to which the missing value corresponds is examined.
The machine 1 is now ready for execution of a measurement cycle.
The sample collection and measurement cycle is repeated at approximately 5 minute intervals.
A first output 55 after the first counting stage subdivides the measurement cycle in two.
Preferably, the measurement cycle starts at the same time as the product cycle.
For example, it is possible to perform the measurement cycle that is described below.
About 5 s are adequate to resurface the electrode with copper in preparation for a new measurement cycle.
Only two phases are necessary per measurement cycle with resistive sensor 2.
Fig . 7 shows the timing of the data acquisition and processing during the measurement cycle.
Figure 1 shows a plot of a typical full measurement cycle of raw GlucoWatch biographer data.
Each measurement cycle includes four sub-cycles effected by successive selection of the four emitting probes.
The first-fit flag is set when a new measurement cycle is started.
The measurement cycle performed by the ohmmeter of FIG . 1 is terminated as follows.
This shunt or " dwell " time provides a delay for discharging dielectric absorption during each measurement cycle.
The steps of a complete measurement cycle are illustrated in the block diagram of FIG . 9.
You'll also be interested in:
Examples of using Measurement
Show more
Market risk measurement and limits in trading
Systolic or diastolic pressure was outside the measurement
Airflow measurement and revision of test standards
Examples of using Cycle
Show more
The cycle can be delayed up to nine hours
Press repeatedly to cycle through menu options
Cycle through different information display modes
