Examples of 'measuring cycle' in a sentence
Meaning of "measuring cycle"
measuring cycle ~ Measuring cycle refers to a sequence of steps or operations involved in obtaining measurements or data for a particular purpose. It typically includes activities such as data collection, analysis, and recording, following a predefined set of procedures or protocols
How to use "measuring cycle" in a sentence
Basic
Advanced
measuring cycle
The measuring cycle requires an adapted postprocessor.
Then a new injection and measuring cycle is started.
A measuring cycle is divided into two periods.
Do not move or talk during the measuring cycle.
Another measuring cycle may then be activated.
A long beep denotes the end of the measuring cycle.
The measuring cycle is carried out according to the previous test.
The balance is tared before start of the measuring cycle.
The measuring cycle begins by the start of the ramp signal.
Measurements are performed at least at two time points during a measuring cycle.
The various phases of a measuring cycle are also indicated in the following table.
The sampling cycle is usually shorter than the measuring cycle.
The smallest possible measuring cycle depends on the number and type of probes connected.
One sample is obtained for each digital signal in one measuring cycle.
The measuring cycle is immediately cancelled and a protocol with the corresponding information is printed.
See also
Low maintenance due to automatic flushing of sensor and cable after each measuring cycle.
Each measuring cycle lasted 6 minutes on average.
The order of the positive and negative biasing can be altered in each measuring cycle.
Thereby, the measuring cycle is repeated steadily.
Show readings directly Setting up measuring cycle.
Starting the measuring cycle by using an appropriate signal ;.
This suffices for a two-minute measuring cycle.
Press / to set the measuring cycle in hours and confirm with.
A mean of these 8 electrostatic forces may be defined for each measuring cycle.
Press / to set the measuring cycle in minutes and confirm with.
Each pair of capacitors is biased in succession in each phase P 1 in a measuring cycle.
The method can comprise at least a measuring cycle defined by the stages as follows,.
If the difference DRL is lower than this threshold sl, a new measuring cycle begins.
Oxygen consumption during the measuring cycle is 1 mg / l and relatively oxygen consumption 100 %.
The sample is kept in the measuring unit for a period of time, i.e. a measuring cycle.
There are three phases P 1 per half-period of the measuring cycle for each respective measuring axis.
If device stays in info mode for longer than 15 s, device automatically returns to measuring cycle.
This detection is carried out with a measuring cycle in the range of 1 µs… 1 sec.
The detachment force was measured at a sampling rate of 25 measurements / second throughout the measuring cycle.
The system according to claim 2, wherein the measuring cycle has a duration of about 10 s.
Preferably the measuring cycle varies between 1 minutes and 3 hours, more preferably between 15 minutes and 2 hours.
Every 4 minutes, a complete measuring cycle is run in which,.
Location measuring cycle Within 40 seconds.
For an application of this type, a complete capillary pressure measuring cycle must hence comprise ( FIG . 1 ),.
Oxygen consumption during the measuring cycle is thus 1 mg / l and relative oxygen consumption 17 %.
You'll also be interested in:
Examples of using Measuring
Show more
Method of measuring the response time on vehicles
Manufacturer of the separate temperature measuring equipment
The measuring instrument is not water tight
Examples of using Cycle
Show more
The cycle can be delayed up to nine hours
Press repeatedly to cycle through menu options
Cycle through different information display modes
