Examples of 'micro-controller' in a sentence
Meaning of "micro-controller"
A micro-controller is a small computer on a single integrated circuit chip used to control devices and perform tasks
How to use "micro-controller" in a sentence
Basic
Advanced
micro-controller
Every micro-controller requires a clock to operate.
Uploading the firmware to the micro-controller.
Micro-controller protected against current attacks.
A flash memory micro-controller is acceptable.
Write code and upload it to the micro-controller.
The controller has a micro-controller with embedded software.
A configuring device for an electronic micro-controller unit.
The micro-controller can also be used for other functions.
All functions monitored by micro-controller.
The micro-controller controls the overall operation of the apparatus.
Arduino is an open source micro-controller.
Micro-controller which is intended to exchange data with said integrated circuit ;.
Understand different components of a micro-controller and their interactions.
The latter can be obtained by means of software implemented on a micro-controller.
Communication with the micro-controller happens over the serial port.
See also
The power supplied is regulated by means of said micro-controller.
Peripheral port is coupled to the micro-controller and connects to the host computer?
Protocol and bus link system between components of a micro-controller.
Second micro-controller 4 sends information on its own presence by means of a synchronization signal.
The signals are processed by silicon blocks within the micro-controller.
The micro-controller adjusts the speed of the device so as to maintain an optimal speed.
This digital signal can then be read by the micro-controller.
A micro-controller articulates a drawing arm in real time based on the fly 's movements.
At least one module is executable by a micro-controller of the secure module ; and.
The algorithm is designed to ensure proper bus management by the micro-controller.
The micro-controller and the transmitter may both be formed on a monolithic chip.
The value of the threshold voltage can be stored in the micro-controller.
The micro-controller is disposed proximate the housing and the dosage sensor.
The timers and interrupt registers of the micro-controller are cleared first.
The micro-controller is electronically coupled to both the detector and the transmitter.
The drive system may be connected to a controller such as a micro-controller or microprocessor.
A primary responsibility of the micro-controller is to monitor and control the communication bus.
Although this drone is as easy as pie to operate, there is also a micro-controller option.
For this the charger micro-controller will monitor several parameters of the battery.
Preferably, these pressure sequences are stored beforehand in a rewritable memory of the micro-controller.
Connect the second radio transmitter to the micro-controller attached to the computer.
The processing of the data is carried out in a digital manner by virtue of a micro-controller.
Both steps are synchronized by a micro-controller which guarantees a fast and reliable measurement routine.
The block diagram illustrates high-level functional aspects of the micro-controller.
Micro-controller clock driven by a quartz by reason of the precision required for time measurements.
The device is then restarted and the micro-controller then reestablishes the contact.
The micro-controller and radio transmitter interfaces have been designated for this connection.
These variables can be adjusted vía the micro-controller to pre-determined values or by manual adjustment.
In this case, the controller advantageously assumes the form of a suitably programmed micro-controller.
The micro-controller also provides closed loop control for tight control over lamp power.
Moreover, the strip port connector is configured in electrical communication with the micro-controller.
The same micro-controller is used in all VFE effects.
The signals of the measuring system and temperature sensor are processed by the micro-controller.
Connect the second micro-controller to an available USB port on the computer.
The dummy controls and dummy indicators are connected to a micro-controller of the driver trainer system.
