Examples of 'microswitch' in a sentence
Meaning of "microswitch"
microswitch (noun) - a type of electrical switch that is actuated by very small physical movements, often used in appliances, machinery, and industrial applications for precise control
Show more definitions
- An electrical switch that operates with very little travel of (or pressure on) the actuator.
How to use "microswitch" in a sentence
Basic
Advanced
microswitch
Release the microswitch after three seconds.
Preferably the first switch may be a microswitch.
Switch dial to the microswitch trigger point.
This microswitch may have various constitutions.
However the polarity of the microswitch is reversed.
Check the microswitch of the condensate tank rocker.
Pump with the addition of the microswitch.
Limit stop microswitch microswitch microswitch.
Release monitoring assembly with microswitch.
Method for fabricating a microswitch actuatable by a magnetic field.
A microswitch shows when a full circuit has been completed.
Single or double microswitch options are offered.
Short cycles thanks to integrated microswitch.
The microswitch is connected to metallic terminals.
The screw is accessible via a hole in the microswitch.
See also
The microswitch can be a dual microswitch.
Disconnect the connector of the microswitch and controller.
The microswitch does not support a lot of activations.
Down position using adjusting stop and microswitch.
Firmware revert microswitch location on the rear of the encoder.
This device enables therefore to do away with a microswitch.
With microswitch and retarder drive and with pedal.
It is of course possible to use a bistable microswitch.
Change the microswitch position axially using a feeler gauge.
The invention also pertains to a microswitch of this kind.
A microswitch provides the start trigger signal at minimum pressure.
The key is present and the microswitch therefore on.
The microswitch located on the an eventual second motor can be.
Such mechanism is a steel wire sensor connected to a microswitch.
The firmware revert microswitch on the rear of the camera.
Be too low to close the microswitch.
The firmware revert microswitch between the status LEDs.
The microswitch is therefore released and a call point is actuated.
The seat is fitted with a microswitch to sense operator presence.
Attackers are therefore able to disable or work around a microswitch alarm.
Make sure that the microswitch block is in proper position.
Single actuated dual microswitch.
The capacitor and microswitch are used to start the motor.
Touch pressure switch including a manually operated safety microswitch.
This microswitch is a dual switch.
Check that the condensate container microswitch is functioning correctly.
Replace the microswitch if the adjustment does not solve the problem.
This pressure washer is equipped with a microswitch sensitive to water flow.
Microswitch with cable.
The firmware revert microswitch on the side of the dome camera.
Rotate the internal cam anticlockwise until the microswitch clicks.
A microswitch is thus produced.
Now turn the limitswitch dial to the microswitch trigger point.
The microswitch is shown in its initial position before its activation.
Split contact microswitch.
