Examples of 'midspan' in a sentence
Meaning of "midspan"
Midspan (noun): In engineering, midspan refers to the midpoint or middle section of a bridge, beam, or any other structure. It is a critical area for structural analysis and support
Show more definitions
- In structural engineering, the point on a flexural member (typically a beam, girder, or spandrel panel) that is equidistant from the two end supports.
How to use "midspan" in a sentence
Basic
Advanced
midspan
Make sure the midspan is properly grounded.
Follow these instructions to connect the midspan.
The midspan deflection should be recorded during the test.
Axis recommends using the supplied midspan.
Midspan insertion is done on unused pairs rather than the signal line.
Sitting on the cord near midspan.
Do not cover the midspan or block the airflow to the PoE with.
The core is disposed in the midspan of the beam.
Continuous beams with a slab in tension at supports but not at midspan.
Keep the midspan away from excessive heat and humidity and.
Do not use countersunk screws when mounting the midspan.
Check that the indicator LEDs on the midspan indicate the correct conditions.
Keep the midspan away from excessive heat and humidity and free from vibration and dust.
Make sure that the LEDs on the midspan indicate the correct conditions.
Try to reconnect the same powered device into a different Midspan.
See also
Method for accessing optical fibers in the midspan region of an optical fiber cable.
The PoE Midspan may be wall or bench mounted using the rear side holes.
Note the following before mounting the PoE Midspan to a fixed location.
You must use a PoE midspan or ensure that your network switch provides PoE.
Try to reconnect the same PD into a different Midspan.
Verify the Midspan detects a device.
Midspan with pre-installed power cable power cable country specific.
PoE devices higher than class 4 require additional midspan.
The Midspan did not detect a PD and therefore the port is not enabled.
No ON-OFF switch exists, simply plug the midspan into an AC power source.
Connect the midspan ( data and power out ) to the camera using the network cable that.
There is no " on-off " switch, simply plug the PoE Midspan into an AC power source.
As a result, the PoE Midspan delivers both data and power to the terminal.
Adjust alternator pulley so belt ( B ) deflects 7 to 9 mm with a 10 kgf push at midspan between pulleys.
Connect the midspan ( Data in ) to the network switch using a shielded network cable STP.
Power over Ethernet midspan ( 1 port ) including mains cable.
At the midspan a temporarily supporting frame ( 9 ) is positioned.
For information on the LEDs on the midspan, see Midspan LED Indicators, on page 11.
Connect the midspan ( data in ) to the network switch using a network cable.
Install the supplied midspan, see the Installation Guide delivered with the midspan or.
Connect the midspan ( DATA IN ) to the network switch using.
Connect the midspan ( DATA & POWER OUT ) to the camera.
