Examples of 'milling time' in a sentence
Meaning of "milling time"
milling time: This phrase is used to describe the act of passing time by engaging in aimless or idle activities
How to use "milling time" in a sentence
Basic
Advanced
milling time
The milling time may be reduced as well.
Greater distances between paths result in reduced milling time.
Total milling time was approximately two hours.
Higher recycling percentages are not commonly found because of the considerable increase in milling time.
Also the effect of milling time was investigated.
The milling time will also depend on the particle size desired in the product.
The coercitive field evolution with milling time and crystallite size is also discussed.
These images show that the nanotube length decreases when the ball milling time increases.
Increases with milling time and decreases as solids increases.
The decrease in photoactivity as a function of milling time is shown in the Figure.
A reduction in milling time thanks to the high density of the balls.
Thus the inclusion of a proportion of EHC produces a significant saving in milling time.
Additional milling time would doubtless further reduce the median and average particle size.
Figure 8 is a plot of viscosity and solids content versus milling time.
Accordingly, milling time should be optimized for the best outcome in terms of electrical conductivity.
See also
It can be seen that a desirable particle size was achieved in 30 minutes milling time.
Table VIII, Milling time influence on tablet hardness.
Figure 5 illustrates a plot of whiteness and the percentage of brokens as a function of milling time.
The milling time ( in the absence of clogging ).
Figure 3 illustrates a plot of whiteness as a function of milling time for given milling weights.
The total milling time is kept below 10 minutes.
As will also be observed, contrarily, the percentage of brokens decreases with increasing milling time.
Complete complete The milling time and corresponding d50 are reported in Table 2.
For the NiFeCuMo alloy, the spontaneous magnetisation evolution with the milling time is analyzed.
Milling time is preferably between 2 and 48 hours.
As will be observed, the whiteness increases with increasing milling time and increasing milling weight.
Further, the milling time was decreased to 22 hours.
Perfect surface, very good milling time.
The milling time should be about 20 minutes.
The other milling parameters are unchanged, and the milling time is 60 minutes.
Milling time for each example was 60 min.
This procedure was repeated 3 more times for a total milling time of 60 sec.
Total milling time was about 10 minutes.
Figure 2 is a plot of change in DBP vs. milling time.
At the same time, the milling time can be reduced by up to 15.
Example 5 Example 3 was repeated except that the milling time was 4 hours.
The milling time is of 60 minutes.
FIG . 1 demonstrates the relation between the milling time and particle size.
For example, the grinding media wear rate may be less than 0.01 weight percent / hour milling time.
Table 2 - Yellowness Index Yi as function of milling time for formulations of example 2 . Ex. 2a.
Table 1 - Yellowness Index Yi as function of milling time Ex. 1a.
You'll also be interested in:
Examples of using Milling
Show more
Set the milling depth as previously described
Users evaluate a combination of milling and turning
Conventional milling can also work perfectly
Examples of using Time
Show more
Spent a lot of time with the ladies
Time and tide wait for no man
A woman needs time to think things over
