Examples of 'needle plate' in a sentence
Meaning of "needle plate"
In sewing, the needle plate is a metal plate with a small hole that the needle passes through. It is located on the bed of a sewing machine and helps guide the fabric while stitching. The needle plate also houses other components like the feed dogs and bobbin mechanism
How to use "needle plate" in a sentence
Basic
Advanced
needle plate
Area under needle plate needs to be cleaned.
Position the straight stitch needle plate.
Remove needle plate and clean out lint.
Use the straight stitch needle plate.
Needle plate with round hole.
Remove the screws q in the needle plate.
Remove needle plate and check bobbin case.
Thread is tangled below the needle plate.
Needle plate and remove the presser foot.
Always use the right needle plate.
Install the needle plate and the presser foot.
Needle bent and strikes needle plate.
Install the needle plate q so that the horizontal posi.
Remove the screws holding the needle plate.
Lift up needle plate from right corner and slide.
See also
Place the darning plate on the needle plate.
Install the needle plate y with the two screws t.
Always use proper needle plate.
Remove the needle plate using a coin or screwdriver to take.
Place the embroidery plate on the needle plate.
Install the needle plate r with the two screws e.
Clean bobbin case and under needle plate.
Install the needle plate w with the two screws q.
Raise the needle above the needle plate.
Needle plate with small needle entry hole only.
The darning plate is fitted on the needle plate.
Needle plate zigzag for.
Remove the standard needle plate.
Needle plate fits janome.
Assemble the race first then the needle plate.
Needle plate elevation for bar tack and embroidery function.
Straight stitch needle plate.
Remove the needle plate by lifting up the right side of the plate.
Screwdriver for needle plate.
Replace the needle plate inserting the hook into the machine.
Quick release needle plate.
Remove the needle plate setscrew and remove the needle plate.
Attach the seam guide and screw to the needle plate.
Take off the needle plate by loosening the screws on both sides.
Replace the bobbin cover plate onto the needle plate.
Place the desired foot on the needle plate aligning needle holes.
Thread or fabric bits have collected under the needle plate.
Remove the needle plate using a coin or screwdriver to remove the screws.
Place the darning plate on the needle plate as shown in fig.
The needle plate setting knob adjusts the position of the chaining finger.
Make sure that you install the needle plate securely.
Remove the two needle plate screws and take off the needle plate.
The area around the hole in the needle plate is scratched.
The lines on the needle plate and bobbin cover plate help you measure seam width.
Loosen needle clamp screw by using the needle plate screw driver.
You'll also be interested in:
Examples of using Plate
Show more
Put the upper plate on the stove
Face plate in position for shredding paper
Do not submerge hot plate or burners in water
Examples of using Needle
Show more
Wait until the needle totally stops
This needle bearing must be lubricated regularly
It may deflect the needle causing it to break
