Examples of 'nominal diameter' in a sentence
Meaning of "nominal diameter"
This phrase is used in engineering or technical contexts to refer to the specified or theoretical diameter of a component or object. It suggests that the provided diameter measurement is the intended or expected size, without accounting for any variations or tolerances
How to use "nominal diameter" in a sentence
Basic
Advanced
nominal diameter
Is the nominal diameter of the rim expressed in mm.
The shoulder narrows the nominal diameter of the duct.
The nominal diameter is always the maximum diameter.
The balloon is inflated to its nominal diameter expanding the prosthesis.
Nominal diameter mass characteristic breaking.
The choice of plane depends on the nominal diameter of the pipe.
Nominal diameter of a dust particle.
Two or three volume flow ranges are available for each nominal diameter.
The largest nominal diameter for bending off steel bar.
The working layer is then ground to the nominal diameter of the roll.
The nominal diameter of a metric screw is the outer diameter of the thread.
Both have a centerline radius of three times the nominal diameter size.
The nominal diameter shall be marked to the nearest one thousandth of an inch.
The two threads have the same pitch and a nominal diameter.
The nominal diameter and nominal tensile strength are for designation purposes only.
See also
In the área of enlargements and protuberances it shall expand to its nominal diameter.
The nominal diameter nominal tensile strength and wire shape are for designation purposes only.
It is obvious that the diameter of the thread is larger than the nominal diameter.
Motor type Nominal diameter of motor in mm.
The zero line refers to the nominal dimensions such as nominal diameter and nominal length.
Nominal diameter of coil Limit of pot detection switches ON.
The regulatory standards establish a defect tolerance on the nominal diameter for drawn plastic tubes.
O Nominal diameter of the fitting.
In metric systems of measurement, nominal diameter is given in millimetres.
Nominal diameter Smallest scale value Indicating range.
Threads longer than 3x nominal diameter are thus unnecessary.
Up to a maximum overall length of 6 times the nominal diameter.
Outside diameter or nominal diameter for pipe 1 to be connected.
Once released, it expands to assume its nominal diameter.
The visual axis has a nominal diameter of approximately 5 millimeters.
Generally, thread diameters are defined by their nominal diameter.
Nominal diameter of connection pipe flange nominal flange diameter of pipe!
Diameter, according to the nominal diameter of the pipe.
Nominal diameter for round wire, nominal area for flat wire.
The radius is equal to 3 times the nominal diameter.
Rotating couplings in nominal diameter 5 are already part of our standard range.
Obviously, the diameter of the thread is larger than the nominal diameter.
The nominal diameter of bar and nominal tensile strength are for designation purposes 6h! y.
This knitted tube had a nominal diameter of 4mm.
But the nominal diameter is less than 63mm pipe recommended using capacitance connection.
Threads longer than 3 times the nominal diameter are unnecessary.
The nominal diameter of the tube can correspond, for example, to its minimum external diameter.
In fact, this diameter is greater than the nominal diameter of the rim.
The nominal diameter ( mm ) pipe specification indicates that the nominal diameter is the approximate diameter.
Minimum number of twists in each direction with a nominal diameter 'd ' or an equivalent dimension.
For rounds the nominal diameter of the product ( not comprising the machining allowance ) shall be.
This diameter tolerance varies, within each grade, based on the nominal diameter.
Thus desired devations from the tool 's nominal diameter can be obtained see table below.
The nominal diameter of the parallel beam is 10 mm.
This permits for a very close but slidably fit over the nominal diameter of needle 38.
You'll also be interested in:
Examples of using Diameter
Show more
A change in wire diameter results in changed parameters
Diameter of and pressure in the fire mains
The incoming hole diameter on auxiliary terminal
Examples of using Nominal
Show more
It is nominal in a demographic decomposition but quantitative here
Catches are expressed as nominal catches in metric tonnes
The nominal thickness of the interlayer or interlayers
