Examples of 'oil feed' in a sentence
Meaning of "oil feed"
This phrase is commonly used in the context of machinery or engines, referring to the process of supplying oil to lubricate or cool various moving parts. It is crucial for the proper functioning and longevity of the equipment
How to use "oil feed" in a sentence
Basic
Advanced
oil feed
Check the oil feed rate as follows.
This channel is connected to oil feed means.
Check the oil feed rate as described below.
To the left for a slower oil feed rate.
The oil feed will stop.
Turbocharger oil feed pipe.
The heavy oil feed was a refinery atmospheric distillation residual.
It would also be wise to check the oil feed system.
Check the new oil feed does not leak.
Timing is controlled by chain which also has a positive oil feed.
The chain oil feed can cause blockages.
Take special care to clean the oil feed to the blade.
A plurality of said oil feed holes may be radially provided in a line.
Salt water had entered the fuel oil feed lines.
Steam usage in heavy oil feed nozzles performs two functions.
See also
The pour point is also dependent on the type of oil feed.
It has been found that the oil feed may additionally contain nitrogen.
Cut the cable after initially switching off the oil feed.
Gravity or barometric oil feed should not be looked at as a main safety control.
Hydrotreating results in that the sulphur levels in the oil feed are reduced.
One of the oil feed nozzles is always supplied with a regulated flow of oil.
The drain creates a reserve for the oil feed to the two hydraulic apparatuses.
The oil feed hole may be in communication with the first oil passage.
Clean the oil guide groove and oil feed hole in the bar at regular intervals.
Before starting work check the oil level in the tank and the oil feed.
The pressurised oil feed may be deactivated during normal running of the pin bearing.
Chain lubrication Check the oil feed rate.
The oil feed pipe 23 may require special provisions to prevent oil deposition on that pipe.
Typical solvent dewaxing processes mix waxy oil feed with solvent from a solvent recovery system.
Conversion was adjusted by varying catalyst circulation rate and / or oil feed rate.
Diluting of the waxy oil feed stream with solvent ;.
As a result, the oil can be properly fed to oil feed points.
Turn reduce oil feed - N turn the adjusting screw.
The slide bearing is supplied with oil through the oil feed duct 25 for lubrication.
Next, oil feed will be described.
Table 1 shows some properties of the rapeseed oil feed and the prehydrogenated product.
Waxy oil feed rate increases by 8 % due to greater solvent circulation.
Correspondingly, a light gas oil feed will require less cooling.
The refrigerant separated from the oil also flows upward through the oil feed passage ( 35a ).
Screw connection / oil feed line leaking.
Oil feed to the hydrostatic screw is effected through union 1144.
A process for solvent dewaxing a waxy petroleum oil feed stream comprising the steps of,.
The oil feed can contain up to 6000 ppmw of nitrogen compounds.
The engine 's pressurised lubrication system provides the necessary oil feed for this bearing.
Case pressure oil feed path … I think.
The membrane was then stored in 20 % lube oil feed solution.
The control oil feed to the chamber 270 is taken upstream of the hydraulic motor 14.
The principal characteristics of the oil feed are shown in Table 5.
The oil feed pipe 23 comprises an oil supply pipe 32 concentrically disposed inside an air pipe 33.
A process according to Claim 1, in which the vacuum gas oil feed to hydrocracking has.
