Examples of 'on-hook' in a sentence
Meaning of "on-hook"
On-hook means to put a telephone receiver back in its cradle, typically to end a phone call
Show more definitions
- Describing the state of a telephone (or similar device) when it is available but not in use
- Describing the idle state of a subscriber or PBX user loop
How to use "on-hook" in a sentence
Basic
Advanced
on-hook
Press the on-hook contact with your finger.
You can stop the ringing by pressing the on-hook.
On-hook dialing for convenient call setup or access to voice mail.
It sends a complementary logic signal if it detects the on-hook state.
Press the on-hook button when you want to terminate the call.
Save a new entry in the phone book by on-hook dial mode.
Press the on-hook key to hang up or put the handset back on the base.
In the measurement phase, all the phones in the customer premises should be on-hook.
Press on-hook key to exit the menu without taking any modifications into account.
Turn the hook in the receiver cradle so that the receiver can be placed on-hook.
With handset on-hook press the Loudspeaker key.
Slide switch to MONITOR to go back on-hook disconnect.
The On-hook function of the state diagram is unchanged.
Monitor and record when the TE goes back on-hook.
Most modems still remain on-hook and respond with OK.
See also
The utility or COSU terminates the call by going on-hook.
The COSU returns On-Hook to complete the signaling protocol.
The call is terminated by the COSU sending On-Hook to the switch.
Or In the on-hook position use and to scroll through the caller.
The COSU completes the protocol by sending the switch an On-Hook signal.
By pressing the On-hook key you will return to standby state.
DiaLing a number stored in memory When phone is on-hook.
The MICC presents an on-hook to the switch and become inactive.
Disconnect is defined as the time at which the COSU or MICC goes on-hook.
The switch sends On-Hook to the COSU to complete the protocol.
MICC initiated disconnect In this case, the MICC initiates the disconnect by going on-hook.
The MICC signals on-hook to the switch and become inactive.
End office B checks the called telephone number for on-hook and active call features.
To favor the going on-hook of the mobile terminals to the dummy base station BTS F.
Integrated handsfree and on-hook dialing.
Follow the On-Hook Dialling procedures to make and answer calls by pushing the SPEAKER.
Receiver is not placed on-hook properly.
Press the on-hook button to end the call.
To put your phone off-hook for on-hook dialling.
Operation with On-Hook Dialling and Predialling.
On-hook button / back to idle state / switch off and on handset longpress.
Receiver is not placed properly on-hook or handsfree is still switched on red LED on.
On-hook dialing - lets you dial and listen without picking up the handset.
After finishing your call, press the on-hook button to hang up.
When the on-hook is detected, the apparatus is returned to the standby mode.
When the other handset picks up, press the on-hook key to hang up and.
In on-hook state, press the MENU button to enter the setting mode.
The mechanisms described so far only allow circuit seizure - on-hook and off-hook - to be signaled.
Switches between on-hook and off-hook when manually sending a FAX.
As a result, the COSU indicates on-hook to the switch.
In the on-hook status, repeat press REDIAL button to check the last 8 outgoing.
In this case, the MICC initiates the disconnect by going on-hook.
The line is sent the CPE On-Hook alert signal and sub-address.
When the ring signal sounds ; press the On-hook key.
The switch then sends the CPE On-Hook alert signal and sub-address.
