Examples of 'output resistance' in a sentence
Meaning of "output resistance"
Output Resistance: In the context of electronics, output resistance refers to the equivalent resistance that a circuit presents to the load connected to its output
How to use "output resistance" in a sentence
Basic
Advanced
output resistance
The voltage loss of output resistance can be neglected.
Output resistance remains constant regardless of amount of use.
An idealized treatment of output resistance is given in the footnote.
Output resistance against violence an unrelenting hostility of the living.
Reduction of the input transconductance Reduction of the output resistance.
Is the output resistance of the inverter.
This has the effect of increasing the parallel output resistance RB.
Of the output resistance.
However, real amplifiers have output resistance.
Cell output resistance remains as the dominant factor in the initiation of thermal runaway.
Figure 3 shows a bipolar current mirror with emitter resistors to increase its output resistance.
Nonzero output resistance - important for low resistance loads.
For a large gain Av ≫ rπ / RE the maximum output resistance obtained with this circuit is.
Is the output resistance due to channel length modulation, calculated using the Shichman-Hodges model as.
The amplifier 39 transmits this signal to the output terminal 9, with a low output resistance.
See also
Output resistance R 0 of the first and second buffers must comply with the following inequation, EPMATHMARKEREP.
In the Shichman - Hodges model used above, output resistance is given as,.
The equivalent output resistance of the driver circuit 14 ' is represented as resistors Rs.
Figure 3: Gain-boosted current mirror with op-amp feedback to increase output resistance.
Using the figure, the output resistance is determined using Kirchhoff 's laws.
Therefore, the transistor Q2 constitutes a voltage generator having a low output resistance Ro ( Q2 ), which is equal to,.
Output resistance is found using a small-signal model for the circuit, shown in Figure 2.
When the model is connected, the output resistance at 10 A overload should be about 55 Ohm.
The output resistance of the potentiometer 570 varies with the rotation of the potentiometer shaft 560.
You'll also be interested in:
Examples of using Output
Show more
One output will contribute to this outcome
Illuminates when output is sent to the tray
Output signals common to measuring technology are available
Examples of using Resistance
Show more
National resistance to the occupation was therefore legitimate
This must result in a resistance value of approx
Resistance to surface damage by fine particles optional
