Examples of 'oxide content' in a sentence
Meaning of "oxide content"
oxide content: This phrase refers to the amount or concentration of oxides present in a substance. It is commonly used in chemistry and materials science to describe the quantity of oxide compounds in a compound or mixture
How to use "oxide content" in a sentence
Basic
Advanced
oxide content
Measurement of nitrogen oxide content in conventional flamescarfing shop.
Determining the nitrogen oxide content.
The oxide content in such materials is usually very low.
The nitrite concentration was proportional to nitric oxide content.
The vanadium oxide content of this compound is determined by thermogravimetric analysis.
The nitrite concentration was proportional to nitric oxide content being formed.
The metal oxide content can be varied according to the applications.
These are alcohol ethoxylates that differ only in the ethylene oxide content.
The variations in the nitrous oxide content of the liquid are continuously detected.
These surfactants vary in wetting ability as the ethylene oxide content varies.
Nitrogen oxide content is the leading criterion when assessing air quality.
Block copolymers with low ethylene oxide content are the most effective defoamers.
The surface oxide content of the activated carbon is adjusted through each of the treatments.
They have a particularly appreciable melting effect in compositions with low alkaline oxide content.
The higher the alkylene oxide content the higher the hydrophilicity.
See also
Preferred talcs and clays are uncalcined having very low free metal oxide content.
A large part of the alkaline oxide content is eliminated during treatment in the flame.
Gel permeation chromatographies also show an increase in polydispersity when the propylene oxide content increases.
The yttrium oxide content lies in the same range as that of ferritic alloys.
The following formula shall be used to convert the calcium oxide content into a calcium content.
The crystalline chromium oxide content of the catalysts were determined using XRD analysis.
This ratio satisfies the requirements of relative high polyalkylene oxide content and good extrudability.
At a zero vanadium oxide content the layer has a very high resistance and a highly negative TCR.
Figure 10 illustrates a graph of efficiency of the photocatalyst as a function of tungsten oxide content.
Falling below the respective alkaline oxide content has the disadvantage that the fusibility is worsened.
A quicklime contains essentially calcium oxide, sometimes with a small magnesium oxide content.
The nitrous oxide content of the liquid is continuously measured ;.
Chlorophyll absorption in healthy plants, iron oxide content in soils, water sediment load.
The nitrous oxide content is measured with an infrared radiation analyzer ;.
Sample was taken to determine free amine, hydrogen peroxide, and amine oxide content.
Too high an alkali-metal oxide content increases the tendency of the glass to devitrify.
Multiple metal oxide / polymer coatings can also be employed to increase the metal oxide content.
The nitrous oxide content of the liquid which accumulates in the vaporizer-condenser is measured ;.
For both methods of treatment the iron oxide content in the slag remains below 6 %.
Multiple metal oxide / polymer coating scan also be employed to increase the metal oxide content.
Example 8 shows a glass in which the zinc oxide content is outside of the claimed range.
The residue from the above sol-gel was also analyzed for its percentage oxide content.
The residual alkylene oxide content of the material leaving the reactor is preferably below 1 ppm.
This industrial catalyst had a titanium oxide content of 85 % by weight.
The iron oxide content of the oil shale is reduced in Zone 3.
Additionally the polyisocyanate has an ethylene oxide content of 2 to 20 % within polyether chains.
Glasses with lead oxide content first appeared in Mesopotamia, the birthplace of the glass industry.
The higher the modulus, the lower the zeolite 's aluminum oxide content.
Without pressure reduction, the propene oxide content in the organic phase was determined by GC-MS.
A sodium oxide content less than 0.5 % produces optimal catalytic activity for this particular application.
The residual ethylene oxide content is 30 vol ppm.
The iron oxide content was calculated to be 5 % by weight of the catalyst.
Optional mention of the water-soluble magnesium oxide content where higher than 5 % MgO.
The iron oxide content of the particles was 9 %.
After cooling, the reaction product with a butylene oxide content of 59 % is a clear amber liquid.
You'll also be interested in:
Examples of using Content
Show more
On the product content and environmental release
Content management interfaces for web systems
Adjusts style and content when necessary
Examples of using Oxide
Show more
Uranium oxide comes in powder or pellet form
The molecule aluminum oxide is aluminum oxide
Tin oxide with hamachi indigo dye
