Examples of 'pad driver' in a sentence
Meaning of "pad driver"
A pad driver is a tool or equipment used for cleaning or buffing floors. It is typically a heavy-duty attachment or accessory that is used with a floor machine or buffer to hold and secure the cleaning or buffing pads
How to use "pad driver" in a sentence
Basic
Advanced
pad driver
Replacement brushes and pad driver group.
Put a brush or pad driver under the brush motor plate.
Check rotation of the pad driver.
The pad driver assembly is on the bottom underside of the machine.
Check the pad and pad driver for damage.
Carefully center the pad onto the pad driver.
Install pad in center of pad driver and lower machine to floor.
Remove the central part of the grip face pulling it off the pad driver.
Raise pad driver and squeegee off floor to prevent damage.
Tilt machine back and remove pad driver or brush.
This allows the pad driver transistors to function as a split termination.
Push down on two sides of the brush or pad driver until the.
The brush and pad driver both attach in the same manner.
Do not store the machine with the brush or pad driver installed.
Before installing pad driver or brush make sure mounting surface is clean.
See also
Never store the machine with the pad driver on the machine.
Turn the brush or pad driver clockwise until it disengages and lift off.
Disconnect the power cord from the electrical outlet before installing a brush or pad driver.
Always remove the brush or pad driver when the machine is not in use.
Carefully center the pad on the pad driver B.
For Pad Installation Attach pad to pad driver before installing driver to motor hub.
To attach pad to driver, remove plastic centerlock ring from pad driver.
Push down on two sides of the brush or pad driver until the gimbals release.
Brushes, pad driver and pads must be purchased separately.
Store machine in a dry area with squeegee removed and pad driver in the raised position.
To remove the brush or pad driver from the machine, follow this procedure.
Remove squeegee assembly, brush housing and brush or pad driver before loading.
Install the brush, pad driver with pad or attachment.
To lock the brush or pad into position, turn the brush or pad driver clockwise.
Position the pad on the pad driver and replace centerlock ring by turning it counter-clockwise.
If machine vibrates, replace pad driver.
For pad installation, center pad driver on pad and tap with hand to secure Figure 6.
Check the pad for wearing status ; if necessary, replace the pad driver.
Never store a low speed machine with the pad driver or brush mounted to the machine 3.
Preferred orbital driver assemblies comprise a driver motor, a driver plate, a bearing assembly, and a pad driver.
Brush, pad driver & pad installation.
Align the lugs ( 1 ) on the locking plate into the pad driver adapter openings 2.
Check the pad driver for wear & if necessary, replace the pad driver.4.
Remove the central screw on the bottom of the pad driver with a 3/4 wrench Fig.1.
Damage to the pad driver can also occur if the pad is less than 1/8 ” thick.
You'll also be interested in:
Examples of using Pad
Show more
The pad has to be replaced in that case
Brake lining or brake pad method of attachment
Launch pad runs completely on internal power
Examples of using Driver
Show more
They look to the driver as their father
Driver did not go down without a fight though
Check whether the driver is installed properly
