Examples of 'percent elongation' in a sentence
Meaning of "percent elongation"
percent elongation - A term used in materials science and engineering to describe the increase in length of a material under tension, usually expressed as a percentage of its original length
How to use "percent elongation" in a sentence
Basic
Advanced
percent elongation
Material is necked down at applied percent elongation.
Represents the percent elongation at break.
Three samples of a given material are tested at each percent elongation.
Average percent elongation at break.
Elongation at break is also called strain at break or percent elongation.
The tensile and the percent elongation at break was also recorded.
ESCR is determined by measuring percent elongation.
Two tenths of one percent elongation is arbitrarily set as the yield point.
The film was placed on the pallet wrapper and stretched wrapped beginning at 0 percent elongation.
This number was used to derive a percent elongation as compared to the original length.
The percent elongation is then measured at the point where the test is stopped.
The abscissae in the figures represent percent elongation and the ordinates the load in pounds.
The ASTM standards also establish maximum deformation stress at 500 percent elongation.
The PLCE at a given percent elongation is the average of five measurements.
The primer described above exhibits greater than 20 percent elongation when tested as above.
See also
Tensile strength and percent elongation were calculated by the Instron â„¢ software.
Permanent deformation is measured at 200 percent elongation.
Stroke, consists in estimating the percent elongation or shortening of the sample during a transition.
Percent Elongation in 2 in.
The mat was prestretched to at least 5 percent elongation and attached to a seat frame.
Some show percent elongation of ∼ 20 % although most fracture at significantly lower values.
Preferably, the film has a rewet percent elongation at break of at least 55 %.
Recovery is measured in these examples after 2 cycles to 100 percent elongation.
The device also recorded the percent elongation at break to the nearest 10 percent.
An effective gauge length of 2.225 cm was used to calculate the percent elongation.
However, within a given region, the percent elongation is substantially constant over that region.
Maximum or 100 percent extension of the gatherable web was achieved at 160 percent elongation.
The PLCE at a given percent elongation is the average of five measurements . Hysteresis Test.
Record peak load in Kg / m ( lbs / in ) and percent elongation.
The force, up to 20 percent elongation of the sample, is recorded at specified elongations.
Figure 4 presents the deformation stress and 500 percent elongation for the same mixes, in a similar format.
Percent elongation at break ( " Eb " ) was measured on the sixth extension cycle.
CD elongation is a measure of the percent elongation a test sample exhibits under a load of 500g.
Percent elongation at break ( " Eb " ) and tenacity were measured on the sixth extension.
In ksi, the percent elongation % El.
Percent elongation was tested in accordance with the test procedure described in ASTM D-2256.
Tensile strength and percent elongation were determined on free films according to ASTM D 412.
You'll also be interested in:
Examples of using Percent
Show more
One hundred percent successful delivery rate
Management wants us to cut another ten percent
I will give you ten percent of my winnings
Examples of using Elongation
Show more
Elongation of the parietal and occipital regions
In order to terminate elongation dephosphorylation must occur
Elongation at half the knot breaking load
