Examples of 'pins must' in a sentence
Meaning of "pins must"
pins must - Could be a misspelling; the intended phrase might be 'plans must,' indicating that certain arrangements or preparations are necessary
How to use "pins must" in a sentence
Basic
Advanced
pins must
Two pins must be machined per opening.
Electrical equipment equipped with round pins must be brought with a flat plug adapter.
Pins must be driven straight into the material.
Traditional deadbolts have standard cylinders where a series of pins must align to unlock the door.
The pins must be protected against welding splatter.
Whenever universal twist couplings are used, lock pins must be.
The plug pins must t the receptacle outlet.
When universal twist couplings are used, lock pins must be installed.
Tipping pins must be correctly interlocked.
Before using them in the process, the oxide layer on these pins must be removed.
The pins must then be extracted.
Electrical equipment equipped with round pins must be brought with a flat-pin adapter.
The servo pins must point toward the nose or tail of the fuselage.
During transport and storage, impacts to the shaft ends and drive pins must be avoided.
The plug pins must fit the receptacle outlet.
See also
And finally, the pins must be cleaned.
The servo pins must always point toward the nose or tail of the aircraft.
The distance between the two guide pins must be confirmed to be 18.5 mm.
These PINs must be entered at the corresponding ports in the Control Center.
And blasting all those pins must have made you thirsty, too.
The pins must be free-moving on both sides.
Mmm, mmm, mmm! And blasting all those pins must have made you thirsty, too.
These red pins must be the homes he 's already torched.
Status LED and the pins must face towards the display.
The pins must be removed and re-inserted into the doll for a fresh healing session.
For double oven ranges, the pins must be placed in the outer two hinges.
PINs must be a minimum length of 7 and maximum 15 digits.
Note that the VCC and Ground pins must be connected correctly to avoid possible damage.
The plug pins must fit the receptacle ( outlet ) . Do not use with an ungrounded system.
Note that the VCC and GND pins must be connected correctly to avoid possible damage.
The lock pins must be driven in for the 1st to 5th.
All pins must fall.
The catching pins must fit in the corresponding grooves.
Those pins must be purchased.
Both guide pins must abut slightly on the saw band.
The top trim 's pins must enter into the downdraft plastic clips.
Note, The locking pins must be fully inserted into the holes in the hinges.
All pins must fall . Dem 's da rules.
