Examples of 'plate thickness' in a sentence
Meaning of "plate thickness"
plate thickness ~ the measurement of the distance between the two surfaces of a solid plate or object
How to use "plate thickness" in a sentence
Basic
Advanced
plate thickness
Steel indicates the plate thickness in mm.
The plate thickness is also shown.
Reduced section size and plate thickness increase softening.
The plate thickness calculated using the following formula.
Ductility across the plate thickness was also measured.
Plate thickness counter down.
Complement ftest plate thickness.
Plate thickness depends on the length and type of the matrix.
Epiphyseal plate thickness.
Plate thickness is important because cooling rate is slower in thin plate.
Mm of maximum plate thickness.
Mm plate thickness.
One would expect that an effect of plate thickness would be apparent.
The required trace wave number is almost completely unaffected by plate thickness.
Reduced plate thickness.
See also
The plate thickness and solvent system employed are indicated in the particular example.
This is continued until the desired plate thickness has been achieved.
Normally this engineering translates as a change in grid thickness and corresponding plate thickness.
Chain plate thickness.
The roll pitch the water pressure the plate thickness the time.
Body plate thickness.
The pipe penetrates the plural fins from the plate thickness direction.
Increase of the plate thickness due to heat generated from friction.
The operator simply opens or closes the clamps without regard to plate thickness.
Such a reduction in plate thickness will yield significant cost savings.
You do not need to bundle jobs with the same material type or plate thickness.
Measure the end plate thickness using a micrometer with a domed anvil.
This method is more economical than the previous ones only for high plate thickness.
This is attributed to the decreasing plate thickness and represents a more homogeneous material.
The plural heat transfer tubes penetrate the plural fins from the plate thickness direction.
The hole penetrates the yoke in a plate thickness direction and the recess does not penetrate.
Plate thickness edge distance e < äge distance.
Implication of Polar ice class in plate thickness design.
In this case the plate thickness must be set as Cover Offset value.
Tool alloy, high strength throughout the plate thickness.
Objects Plate thickness.
Next, the obtained sintered compact was cold rolled to a plate thickness of 2 mm.
The plate thickness may be reduced to 3 mm.
The as-quenched material was cut in the plate thickness direction.
The single plate thickness in millimeters is shown on the x-axis.
Therefore, it is possible to decrease the plate thickness of the pulser ring.
Ii . the plate thickness calculated using the following formula.
Therefore, it is possible to decrease the plate thickness of the pulsar ring.
However, the plate thickness is at a maximum for the interrogation signals.
As a result, this means causes a problem in terms of ensuring plate thickness accuracy.
If it involves special plate thickness and ink, please let us know.
It is thus preferable to work with a width equal to about 10 times the plate thickness.
In contrast, the exponent of the plate thickness is smaller than in the static case.
For the bipolar plate, the preferred path is parallel to the plate thickness.
Although the thinnest impeller plate thickness is desired, it sometimes can not be achieved.
You'll also be interested in:
Examples of using Plate
Show more
Put the upper plate on the stove
Face plate in position for shredding paper
Do not submerge hot plate or burners in water
Examples of using Thickness
Show more
Minimum recommended thickness of zinc vs thickness of steel
Thickness of tanks made with double walls
Reduction of wall thickness and additional protection
