Examples of 'poor surface' in a sentence
Meaning of "poor surface"
Poor surface: Describes a surface that is of low quality, lacking smoothness or durability
How to use "poor surface" in a sentence
Basic
Advanced
poor surface
Poor surface quality on the planed work.
Furthermore the patterns have a poor surface finish.
Poor surface finish after planing.
This can also lead to a poor surface finish.
Poor surface quality due to vibrations.
Such incrustations result in a poor surface finish of the product.
Poor surface preparation will always show through in the final coat.
This is particularly interesting in the case of poor surface flatness.
Particularly poor surface and ground water balance.
Too much pressure on the wheel can cause a poor surface finish.
These shocks can lead to a poor surface condition of the worked parts.
A poor surface aspect after hemming may be observed on the outer panel.
Use of xanthan results moreover in poor surface coating properties and in a slimy mouthfeel.
Poor surface conditions increase the occurrence of poor player performance and player injury.
The sink showed areas of very poor surface finish on the show surface.
See also
Diamond grinding does not introduce any unusual condition that would lead to poor surface durability.
Large areas of poor surface finish were apparent on the show surface of the sink.
These materials were found to have poor pigmentability and poor surface smoothness by current standards.
The blends exhibited a poor surface film effect which had poor flow out and orange peel.
Often pigmented films formed from resins prepared in this manner have very poor surface appearance.
The large amount of friction results in poor surface finishes and poor overrall quality.
Poor surface preparation, especially when paint is applied to bare wood without priming.
The seamount lies in a region of the Pacific with nutrient poor surface waters.
As a result, poor surface properties are obtained.
Discussion of the Background Synthetic polymer materials possess poor surface properties.
A rating 6 indicates poor surface coverage and large crystal size.
The two most common causes of tool failure and poor surface finishing are,.
The extrudate had a very poor surface appearance and a non-uniform cell structure.
A larger grain will cut freely, allowing fast cutting but poor surface finish.
However, the área and position of poor surface finish remained substantially unchanged.
If lower stoving temperatures are applied, the coatings obtained generally exhibit a poor surface appearance.
Therefore, a distortion or poor surface accuracy results.
Control Example 5 which did not contain an EPDM-g-SAN component had a very poor surface.
That is to say, it had a poor surface strength.
Continuous and / or repeated cycles of exposure to radiant energy may result in poor surface appearance.
Excessive chatter can result in a poor surface finish, rework or scrap of the work product.
Here again, N2 wiping is used to drastically improve such a poor surface quality.
Chatter instability causes poor surface quality, diminishes the tool 's life and may cause clatter.
Substrate conditions, moisture in the substrate and poor surface preparation ;.
This causes vibrations, poor surface finish on the part, and poor tool life.
However, some plasticisers may lead to poor surface characteristics.
Issue 2, Poor surface water quality.
Difficulties in the use of tools, parts deformations or poor surface qualities become problematic.
Just poor surface?
Small cutting edge fractures (frittering) causing poor surface finish and excessive flank wear.
Over-polishing can lead to a poor surface finish e.g. an “ orange peel ” effect.
Moreover, the articles obtained have a poor surface appearance . INVENTION.
You'll also be interested in:
Examples of using Poor
Show more
Poor staff management capacity at all levels
They ate that poor woman alive
The poor thing has suffered a lot
Examples of using Surface
Show more
An uneven surface increases the risk of overturning
Where ϑ is the measured test surface temperature
All feasible surface and subsurface ECVs
