Examples of 'position of the plate' in a sentence
Meaning of "position of the plate"
position of the plate ~ The position of the plate refers to the placement or arrangement of a plate, typically in the context of setting a table for a meal or presentation of food
How to use "position of the plate" in a sentence
Basic
Advanced
position of the plate
Bottom position of the plate head reversed.
An optical encoder makes it possible to know the exact angular position of the plate.
Upper position of the plate head reversed.
The tensile force on the yoke is independent of the longitudinal position of the plate.
Position of the plate in relation to the vertical plane.
Check the horizontal position of the plate with a level.
Position of the plate in relation to the longitudinal axis of the vehicle.
Intraoperative fluoroscopy assesses the position of the plate and confirms that it is satisfactory.
Position of the plate in relation to the longitudinal median plane of the vehicle.
Estimating the volume of allograft required for filling and adjusting the position of the plate.
Upper position of the plate head on the top.
Variation of the Position of the Plate.
Position of the plate in relation to the vertical longitudinal plane of the vehicle.
The rear position defines a low position of the plate 3.
Lateral position of the plate.
See also
The front position defines a high position of the plate 3.
Position of the plate in relation to the longitudinal plane of symmetry of the tractor.
When flexographic printing is used, the position of the plate cylinder may be shifted.
Position of the plate in relation to the longitudinal plane of symmetry of the vehicle.
The three configurations differ essentially by the size and position of the plate 23.
The dimensions and the position of the plate must therefore be highly accurate.
The linear guide 32 is substantially horizontal in the high position of the plate 3.
In the forward position of the plate the container is protected by the pusher unit.
The mechanism 40 indexes the position of the flap 4 on the position of the plate 3.
The position of the plate is maintained during the scratching and breaking operations.
The position x=0 corresponds to the equidistant position of the plate opposite the two electromagnets.
The position of the plate is determined on the basis of the exchanger efficiency tests.
By using two motors, the location and position of the plate can be accurately controlled.
The position of the plate ( film or sensor ) is different.
Based on these measurements, the position of the plate 19 is adjusted automatically.
The position of the plate 11 is fixed relative to the frame 21.
The section view of FIG . 7 b shows the position of the plate 712 in the free state.
In a low position of the plate 110, shown on the right in FIG.
The dot-dashed line shows the position of the plate 15 when the ring 10 is deformed.
Adjust the position of the plate according to the nail length Fig.
The spatial position of the plate cylinder according to three axes ;.
FIG . 6 shows the position of the plate 9 while a document is returning to the cassette 1.
You'll also be interested in:
Examples of using Plate
Show more
Put the upper plate on the stove
Face plate in position for shredding paper
Do not submerge hot plate or burners in water
Examples of using Position
Show more
Then position the unit as shown below
Verify the correct position of the gasket
Try to position cages out of direct sunlight
