Examples of 'pull-off' in a sentence
Meaning of "pull-off"
Pull-off is a noun that refers to a maneuver or event where something is executed successfully, especially in music or sports
Show more definitions
- An area by the side of a road where vehicles may stop; a lay-by.
- The technique, when playing a string instrument, of using a finger of the fret hand to pluck a string by pulling the finger off the fretboard.
- Able to be removed by pulling.
How to use "pull-off" in a sentence
Basic
Advanced
pull-off
A pull-off is basically the opposite of a hammer on.
Summary of the main pull-off testing standards.
Pull-off for tightening overhead contact line.
This technique is the opposite of the pull-off.
A pull-off adhesion tester is employed in the protocol.
Horizontal and vertical pull-off for spools or coils.
The pull-off value can be increased in several other ways.
The second slope may be configured for a pull-off force.
Several pull-off points exist along the road.
As a result, interlaminar tension loading may be reduced at the pull-off interfaces.
There is a pull-off area big enough to accommodate a few cars.
Stacked noodle for high capacity pull-off for a composite stringer.
Ensure appropriate garbage and vault toilet facilities are provided at the pull-off.
To eliminate the above drawback, pull-off package opening systems have been designed.
Deformable substrates or elastic coatings can lead to a falsification of the results of a pull-off test.
See also
Adjacent to the first cooling section a pull-off capstan or similar device is located.
Magnetic pull-off gauges use a permanent magnet, a calibrated spring and a graduated scale.
Consequently, the desirable high levels of pull-off force are sometimes not achieved.
The final composite material is drawn at the die outlet by means of a caterpillar pull-off.
Like the hammer-on and pull-off slides are completely independent of the picking hand.
Equipped with three high quality snap that will not pull-off in the wind.
However, it was found that the pull-off strength of the resultant igniters were extremely low.
Pull-off testing is one of the most widely used test methods in the construction industry.
Clutch release bearing for a clutch of the pull-off type, especially for motor vehicles.
The Pull-Off adhesion testers are fully portable and provide accurate numerical value for coating adhesion.
Method and device for fitting pull-off tabs to pourable food product packaging material.
Straightening elements centrally adjustable on two plains before the line wire pull-off and compensating mechanism.
The maximum measured pull-off force was obtained using sample 9 with the noted dimensions.
Example A connector assembly as described above was tested for pull-off force.
No one can pull-off a military coup in Iraq.
Seeger also invented the term pull-off.
Good correlation between pull-off force and DP was observed.
The Pull-Off Switch is used to control the power of the appliance.
Watch the sunset from a pull-off in Hayden Valley.
In individual pull-off mode, a control PCB communicates with an upstream and a downstream zone.
Before removing separator, first pull-off connected hoses.
Load rate warning Pull-off testing from a single side, is best suited for rigid substrates.
To your masterful pull-off.
Easy pull-off Adjustable suspendersReinforced knee.
Tamper-proof closure with pull-off retaining ring.
O Pull-off on the main parkway near the Information Centre with a map of the park.
The following example shows zone 1 in individual pull-off mode.
Hinged pull-off steady arm in tension.
The coating-substrate bond strength is determined using pull-off testing.
Playing a pull-off is the opposite of a hammer-on.
The material is drawn continuously by the caterpillar pull-off at a speed of 1 m / minute.
Hinged pull-off steady arm.
It's not like there was a lull after the helmet pull-off.
Pull-off registration arm.
Various interaction forces, pull-in and pull-off phenomena are correctly rendered.
