Examples of 'pull-up resistor' in a sentence
Meaning of "pull-up resistor"
pull-up resistor: In the context of electronics, a pull-up resistor is a component used to ensure that a wire is pulled to a high logical level when no other active device is connected
How to use "pull-up resistor" in a sentence
Basic
Advanced
pull-up resistor
An external pull-up resistor is required on this signal.
This is accomplished by adding a pull-up resistor.
External pull-up resistor are no longer needed.
The second output is connected to a reference potential through a pull-up resistor.
Each line has a weak pull-up resistor connected to it.
Preferably the at least one resistor which is monitored is a pull-up resistor.
An external pull-up resistor is generally required to use this pin.
The input / output stage can comprise an open collector or open drain stage with a pull-up resistor.
The appropriate value for the pull-up resistor is limited by two factors.
This pull-up resistor and voltage conditioning circuitry is conventionally located in the smart card reader.
The positive input is furthermore connected to ground via a third pull-up resistor Rp 3.
The pull-up resistor must at times be connected to the output, however.
Is linked to the line IPSL via a pull-up resistor Rpu.
The thermistor RT, a pull-up resistor R2 and a voltage supply Vs can form a voltage divider.
An open-drain configuration requires an external pull-up resistor.
See also
Pull-up resistor to VDD.
This module contains a push button and a pull-up resistor of 10 kOhm.
The pull-up resistor 72 prevents a short to ground.
The reset input also is connected to a positive supply voltage V+ by a pull-up resistor 44.
The voltage and transients at the pull-up resistor must not exceed 25 V.
The appearance of the PWM signal is schematically illustrated below the pull-up resistor 11.
Figure 3 shows a location of the pull-up resistor for full-speed and low-speed transceivers, respectively ;.
The MIC communication line is always kept at an " H " level by a pull-up resistor.
A pull-up resistor R27 may be connected between the output of the operational amplifier U8 and +5 volts.
The third voltage level is generated by a pull-up resistor 79.
Receive a maximum of 40 mA and has an internal pull-up resistor ( disconnected by default ) of.
The microcontroller block 902 may also include a crystal oscillator, two pull-down resistors and a pull-up resistor.
The detecting circuit 74 comprises the operating switch SW, a diode D ₁ and a pull-up resistor R ₂.
You'll also be interested in:
Examples of using Resistor
Show more
An external braking resistor can be connected if required
Resistor on the top of the protection cap
Integrated brake resistor without complicated wiring
Examples of using Pull-up
Show more
There has been a pull-up from the underworld
I do not ever want to do another pull-up again
Integrated pull-up resistors for servo function
