Examples of 'pump speed' in a sentence
Meaning of "pump speed"
pump speed: This phrase is related to adjusting or controlling the rate at which a pump operates, typically in terms of how fast it can transfer liquids or gases
How to use "pump speed" in a sentence
Basic
Advanced
pump speed
The pump speed is then no longer controlled.
A computer provides pump speed control signals.
A microcontroller converts this signal to a pump speed.
Maximum pump speed is set by the user.
These control means act to control pump speed.
Pump speed can be changed from pump or controller.
Select the desired pump speed and press.
Pump speed limitation add zone.
This can be done using pump speed.
Check that the pump speed setting is on the highest speed.
Stroke or cycle at a pump speed of.
Pump speed control is achieved by implementing a control loop in hardware or software.
Order to deactivate pump speed control.
The pump speed is proportional to the voltage applied to the pump motor.
The flow rates are set by nominal pump speed settings.
See also
Small changes of pump speed yield very large changes in pressure.
The pressure can be controlled by changing the pump speed.
Control of the pump speed varies blood flow through the pump.
Use the and buttons to set the desired pump speed.
The peristaltic pump speed is set to achieve the desired slurry flow.
In this case an increase of the blood pump speed may occur.
Low pump speed means extended rotor and stator life in abrasive bores.
Analogue controls enable users to set the level of a control such as pump speed.
The pump speed depends on the treatment setting of the extracorporeal treatment apparatus.
The switch located at the front of the pump controls the pump speed.
A pump speed can then be compared to the range and a flow rate read off.
Thinner films may also be obtained by reducing the die gap or pump speed.
The pump speed is then set to provide the flow conditions appropriate for separation.
Sweep time is the timespan for a complete change from minimum to maximum pump speed.
Vacuum pump speed is lowered and the chamber is allowed to equilibrate for ten minutes.
During this period the laser level does not control the molten metal pump speed.
Compensating for water pump speed variations in a tempered air system for vehicle passenger compartments.
A PID controller is used to adjust the carbon pump speed.
Such a configuration would be able to compensate pump speed and ensure a more constant flow rate.
Pump speed limitation main zone Domestic heating water priority.
Screen Control manual for details of programming the pump speed and operating hours.
Remember that reducing pump speed will not affect performance but will affect energy consumption.
See the paragraph on Pump Speed.
Pump speed was set to give a desired Tex and desired tenacity at break.
When there is no heating output, the pump speed limitation is applicable.
The pump speed is set according to the the Jetcutter flow rate used.
As the vehicle engine speed increases, the pump speed increases.
PDP pump speed pa.
When there is no heating / cooling output, the pump speed limitation is applicable.
The pump speed and / or pump pressure may be varied manually or automatically.
During manual operation, you can change the desired pump speed.
Optimisation of vacuum pump speed of rotation, depending on the vacuum required.
In one embodiment, collector rate speed was adjusted as a function of melt pump speed.
Optimisation of vacuum pump speed of rotation, depending onthe vacuum required.
Sensing the speed of the pump and generating an electrical pump speed signal ;.
You'll also be interested in:
Examples of using Pump
Show more
Clean the pump at least twice a year
Check that the drain pump is level
However the pump can be activated in commissioning
Examples of using Speed
Show more
The speed of the vacuum source shall be
I must have hit speed dial by mistake
Zoom speed is determined by the amount of rotation
