Examples of 'punch and die' in a sentence
Meaning of "punch and die"
In manufacturing, 'punch and die' refers to a tooling system used to create holes in a workpiece. The punch is used to remove material from the workpiece, while the die provides support to the workpiece to ensure clean and accurate hole creation.
How to use "punch and die" in a sentence
Basic
Advanced
punch and die
Always replace the punch and die as a set.
Punch and die polishers.
Check that the punch and die are sharp.
Punch and die spring.
Adjusting the punch and die.
The punch and die should be replaced at the same time.
Rotates both the punch and die to any angle.
This complex design is prone to misalignment of the punch and die.
This is when the punch and die should be replaced.
This is in particular visible if using a punch and die method.
Do not touch punch and die during use of the nibbler.
Lack of lubricant will shorten punch and die life.
A worn or defective punch and die will greatly decrease work efficiency.
You will want to replace the punch and die.
The punch and die are preferably liquid cooled to minimise cycle time.
See also
A harder material will dull the punch and die faster than a soft material.
Cutting material thicker than the capacity will cause damage to punch and die set.
Force for the punch and die action will usually be provided by a press.
This simplified embodiment eliminates the requirement for close tolerances between a punch and die.
Replace or sharpen punch and die after cutting the lengths indicated in the accompanying table.
Coat the cutting line with tool oil to increase the punch and die service life.
There are numerous reciprocating punch and die apparatus which will operate successfully in this operation.
Coat the cutting line with machine oil to increase the punch and die service life.
The Punch and Die are instantly adjusted.
Hardened turret sleeves ensure accurate punch and die alignment throughout the life of the machine.
This causes the material to experience highly localized shear stresses between the punch and die.
Quick change punch and die holders speed tool set-up and changeover.
The blank is then drawn into a shallow cup using a cup forming punch and die equipment.
A conventional punch and die set comprises a die assembly 2 and a punch assembly 4.
Cutting materials Service life cutting lengths of punch and die.
Typically, several punch and die combinations are used in sequence to suitably shape a workpiece.
Figure 3 is a partial plan of the apparatus with outlines of a punch and die superimposed ;.
Therein the punch and die profiles are shaped for bending a metal sheet 14 into box form.
At the end of the decompression phase, the punch and die rams are retracted.
Each punch and die set produced approximately 90 tablets per minute.
A drive for controlling relative movement between said punch and die sets ;.
Thereby, the guide device holds the punch and die centered during the cutting step.
Advantageously, the consolidation step is carried out in a toolset comprising a rigid punch and die.
Do you have any punch and die for my Ironworker?
After the unitary sheet is formed, holes are created using a punch and die mechanism.
An edge matching that of the punch and die is formed in the plate Figure 1.
Also, the rigidity of the stamping station facilitates alignment of the punch and die.
Punch and die replacement see Fig . 8.
In ordinary punching, the part deformed by the punch and die shown in FIG.
The engaging member 80 may be formed in the strap 20 with a suitable punch and die.
Removing or installing the punch and die Fig.7.
Diagram 2, forming by pressing with a punch and die.
This machine uses a multi-cavity, progressive shearing action, punch and die set.
You'll also be interested in:
Examples of using Die
Show more
He will want to die when he finds out
To die is what makes life worth living
We thought if we was gonna die we might as well give it a go
Examples of using Punch
Show more
Use a center punch to start the hole
Punch in the time and hit enter
Not that that punch was not awesome
